Loading ...
Loading ...
Loading ...
if blade is NOT SQUARE to table.., the 90 ° LIMIT
STOP must be ADJUSTED.
CAUTION: Cover blade with piece of cardboard to
protect your hand.
1. Using a small size screwdriver, reach
UNDERNEATH saw and loosen BOTH setscrews
in 90 ° STOP COLLAR.
NOTE: If you can't reach the setscrews, turn the
TILT HANDWHEEL slightly,
2. ROTATE the STOP COLLAR mowng it away from
pivot nut.
3. TILT blade RIGHT or LEFT . . . checking with your
square until blade is square to table.
4. ROTATE STOP COLLAR moving it toward
PIVOT NUT until it TOUCHES the PIVOT NUT..
TIGHTEN the setscrews.
5. Check POINTER. if it DOES NOTpointtothe"O
mark on the bevel scale, bend pointer to read "O.
BLADE COVERED
WgTH PIECE OF
CARDBOARD
/
\
I
SETSCREWS (2)
PIVOT NUT \
\
90 ° STOP COLLAR
TILT blade to LEFT as far as it will go It will stop
when the PIVOT NUT is against the 45 ° STOP
COLLAR.
Place an ACCURATE square against blade. Make
sure square is not touching the TIP of one of the saw
TEETH.
/
/
If blade is NOT 45 ° to table . . . the 45 ° STOP
COLLAR must be ADJUSTED
1. Remove Elevation Handwheel,
2. Using a small size screwdriver, reach thru curved
slot in front trip panel and loosen BOTH
setscrews in 45 ° STOP COLLAR.
NOTE: If you can't reach the setscrews, turn the
TILT HANDWHEEL slightly.
3. ROTATE the STOP COLLAR moving it IN or OUT
and TILT blade RIGHT or LEFT...checking with
your square until blade is 45 ° to table.
4. TIGHTEN the setscrews.
NOTE: If you can't reach the setscrews, turn TILT
HANDWHEEL slightly
5. Install Elevation Handwheet.
45°
STOP COLLAR
\
TiLT SCREW
l
BACK OF SAW
I!
Loading ...
Loading ...
Loading ...