Craftsman 113226640 10" direct-drive table saw

User Manual - Page 13

For 113226640.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Insertthree (3) 5/16-18x 1-1/4 in. long screws
throughholesin each EXTENSION then through
table, tnstall flat washer, Iockwashers, and nuts on
the screws... DO NOT TIGHTEN.
Align front edge of extension with front edge of saw
table. Pull Extension UPWARDS above table
surface . . . SLIGHTLY TIGHTEN SCREWS using
1/2 in. wrench.
Using small block of hardwood and hammer, tap
extension DOWNWARDS at front, center and rear,
until it is EVEN with table surface . . . TIGHTEN
SCREWS.
BLOCK OF WOOD
.,? ,2
ALiGNiNG EXTENSIONS
Lay REAR FENCE GUIDE BAR on table to act as a
straightedge. If outer edge of extension is higher or
lower than table surface:
1, Slightly loosen nut holding the corner support
bracket to extension using 7/16 in. wrench.
2. Move end of extension up or down until outer
edge is even with table surface . . . check with
GUIDE BAR ... tighten nuts.
3. Recheck INNERedge of extension to make sure it
has not moved .. readjust, if necessary.
4. Adjust right extension in same manner.
CHECK AT FRONT AND
REAR OF EXTENSION
/
INSTALLING RDP FENCE GUIDE BARS
AND SWITCH
1. Locate the following loose parts:
Hex head screws 5/16-18 x 3/4 ............ 2
External Iockwashers. 5/16 ................. 2
Hex Nuts 5/16-18 ......................... 4
Hex head screws, 5/16-18 x 1-1/2 ........... 2
Hex head screws 5/16-18 x 1 .............. 2
External Lockwashers 5/16 ................ 4
Spacers, 3/4 x 1/2 ......................... 2
Self threading nuts ........................ 2
Washers, 21/64 ........................... 4
Switch Assembly .......................... 1
2. Insert a 1-1/2 inch long screw, external lock-
washer, and flat washer through the sixth hole in
the front fence bar.
3. Place 1/2 inch long spacer over screw th reads and
position screw through first hole on the right side
of the cast iron table skirt.
4. Use fingers to thread screw into tapped hole until
finger tight. Guide bar should be in a vertical
position.
FLAT WASHER _/1-3/4"' SCREW
_'_C_ FRONT FENCE eAR
LOCKWASHER ",-.-,___',_ 1
SPACER _ 6TH HOLE
r_ L.; J
13
Loading ...
Loading ...
Loading ...