Loading ...
Loading ...
Loading ...
BLADE ELEVATION
When the elevation handwheel is turned CLOCK-
WISE, until it stops, the blade must not be more than
two and five eigths (2-5/8) inches above the table. If
the blade extends more than 2-5/8 inches, the motor
could interfere with the underside of the table
causing misalignment.
With the blade extending two and five eigths (2-5/8)
inches above the table, the STOP COLLAR and
SPACER must be against the ELEVATION SCREW
PIVOT NUT. If the blade extends more than 2-5/8
inches, loosen two screws in STOP COLLAR, and
readjust it.
ELEVATION SCREW
/
f
!
/
ELEVATION SCREW
PIVOT NUT
1
\
STOP COLLAF_
TILT SCREW
\,
TILT SCREW
PIVOT NUT
TILT AND ELEVATION MECHANISM
TILT
The HANDWHEELS should turn freely without HANDWHEEI
binding, The turning action can be adjusted by 1
tiqhtening or loosening the screws in the bearing
retainer. Both handwheels must be removed to
reach the adjusting screws. _
NOTE: When adjusting the screws on the TILT
bearing retainer, hold the nut inside using a 3/8 in.
wrench. The screws for the ELEVATION bearina
retainer can be reached with a small screwdrive_r
through the curved slot on the front of the saw.
ADJUST THESE
TWO SCREWS
ADJUST THESE
TWO SCREWS
ELEVATION
HANDWHEEL
1
ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
From among the loose parts find the followin
hardware: (Quantity indicated is for 2 extef
Ref.
No, Description Qty.
1 Corner Support Bracket ............ 4 \\ 3
2 Corner Stiffener Bracket ............ 4
3 Truss Hd. Screw, 1/4-20 x 1 ........ 16 /
_f
4 External Lockwasher, 1/4 ........... 16
5 Hex Nut, 1/4-20 .................... 16
6 Flat Washer (Dia. of Hole 17/64) .... 4
HARDWARE FOR INSTALLING
EXTENSIONS TO SAW TABLE
7 Hex Hd. Screw, 5/16-18 x 1-1/4 ..... 6
8 External Lockwasher, 5/16 .......... 6
9 Hex Nut. 5/16-18 ................... 6
10 Flat Washer (Dia. of Hole 11/32) .... 6
Assemble brackets with hardware as shown.
.TABLE EXTENSION
MOUNT TO TABLE
EXTENSION USING
)N
OPPOSITE SIDE.
__ UNDERSIDE VIEW OF
ASSEMBLED TABLE EXTENSION
12
Loading ...
Loading ...
Loading ...