Loading ...
Loading ...
Loading ...
Connecting Household Water Supply To Refrigerator
To Connect Water Supply Line To Ice
Maker Inlet Valve
1. Disconnect refrigerator from electric
power source.
2. Place end of water supply line into
sink or bucket. Turn ON water supply
and flush supply line until water
Plastic Water Tubing
to Icema
/ Fill Tube
is clear. Turn OFF water supply at
shutoff valve.
Steel
Clamp
.-_ Brass
Compression
Nut
I-- Ferrule
_. (Sleeve)
Copper
water line
3. Unscrew plastic cap from water valve
inlet and discard cap.
4. Slide brass compression nut, then
ferrule (sleeve) onto water supply line,
as shown.
5. Push water supply line into water
valve inlet as far as it will go (1/4
inch). Slide ferrule (sleeve) into valve
6.
\Water Valve
Bracket
L-Valve Inlet
-Water Valve
_J'_._Copper water line from
household water supply
inlet and finger tighten compression f
nut onto valve. Tighten another half
turn with a wrench; DO NOT over
tighten.
With steel clamp and screw, secure
water supply line to rear panel of
refrigerator as shown.
Coil excess water supply line (about
21/2 turns) behind refrigerator as
shown and arrange coils so they do
not vibrate or wear against any other
surface.
(Include enough tubing in loop
to allow moving refrigerator
out for cleaning.)
8. Turn ON water supply at shutoff
valve and tighten any connections
that leak.
9. Reconnect refrigerator to electrical
power source.
10. To turn ice maker on, lower wire
signal arm (see ice maker front cover
for ON/OFF position of arm).
12
Loading ...
Loading ...
Loading ...