Loading ...
Loading ...
Loading ...
ATTACHING THE GUARD ASSEMBLY
8. With one hand, hold the front of the barrier guard assembly 4
by the metal "fork". With the other hand, hold the guard release
lever 5 up (Fig. 7).
9. Lower the rear of guard assembly and slip the cross bar 6 into
the rear notch 7 on top of the riving knife 2 (Fig. 7).
10. Lower the front of the guard assembly 4 until the metal "fork"
is parallel with the table (Fig. 8).
11. Press down on the guard release lever 5 until you feel and
hear it snap into the locking position. Check that the guard
assembly is securely connected (Fig. 8).
\
/
/
/
ATTACHING THE ANTI-KICKBACK DEVICE
12. Attach the Anti-Kickback Device 7 into the flat recessed
area 8 of the riving knife 2 (Fig. 9).
13. Squeeze the compression pads 9 while nesting the device
into the flat area (Fig. 9).
14. Release the compression pads such that the Anti-Kickback
Device locks onto the riving knife immediately behind the guard
assembly. Check that the attachment pin is securely connected
into locking hole. Carefully raise and lower the pawls 10 -when
letting go, the spring-loaded pawls must come down and contact
the table insert (Fig. 9).
Hint: Position the Anti-Kickback Device behind the flat recessed
area and slide it towards the front until it drops into the recessed
area - then release the compression pins.
Note: The two attachments are independant of each other, so
the Anti-Kickback Device can be attached before the Guard
Assembly.
28.
Loading ...
Loading ...
Loading ...