Loading ...
Loading ...
Loading ...
J ,,,,, i _ ,,,,,,,, 1,1,,, • ,,I,H, .... ,,, =1,=,,=, ,,,,, , , ,, ,,...............................................
ASSEMBLY
,,1,, ,,, ,,, , ,H,,,,,,, =,,,i N,,,,, =1=,,, ,, i,,,,,
H,,, H, ,,,,,,,,,!, i i ,,,,,,,,,,,
..................................... ii
TO INSTALL THE SHIFTER LEVER
KNOB
• Stand the snow thrower up on the front of the auger
housing, as shown in Fig 6A,
• Cut the plastic tie which holds the shifter lever
assembly to the shift bracket (Fig 6B).
• Remove the Iocknut, washer, spring and bolt (Fig.
6D) ....
• Reposition the shifter lever into the slot in the
control panel, as shown in Fig 6C and reinstall the
bolt, spring, washer and tocknut.
• Tighten the Iocknut until t/8" to 3/16" (2 or 3 threads)
of the bolt protrude past the locknut.
• Thread the shifter lever knob onto the threaded endof
the shifter lever until it is tight (Fig 6D)
O Movethe shifter lever through allthe speedsto ensure
proper tension of the spring,, If the shifter lever sticks
in any of the notches, loosen the Iocknut 1/4 turn at a
time until the shifter lever moves freely.
TO INSTALL HEADLIGHT
The headlight ismounted on right side ofupper handle and
is installed upside down for shipping purposes
@ Remove the pivot bolt (Fig., 7A), ptace headlight in
correct position (as shown in Fig. 7B and in Fig 2) and
retighten nut.
• Tie the headlight cable to upper and lower handles
with the plastic cable ties supplied in the parts bag by
threading the pointed ends ot each tie through the
square ends and pulling tightly around the headlight
cable and the handle.,
NOTE: One side of the plastic tie has small notches in it,
while the other side is smooth The notched side must be
on the inside ofthe loop which isformed when the ends are
put together
@ Tryto _oosenthe cable tie If itcan be loosened, it has
been attached with the smooth side on the inside of
the loop, Remove the cabletie and reverse itsdirection
SHIFTER
BRACKET
WASHI
1/8 TO 3/16 INCH OF EXPOSED THREADS
FIG, 6
LOCKNUT
O Cut offexcess cable tie,
FIG. 7A FIG. 7B
Loading ...
Loading ...
Loading ...