Loading ...
Loading ...
Loading ...
fr IIH, I ,,',, Ill
............SERVIC ............AN....
TO REPLACE BELTS
The drive belts on this snow thrower are of special
construction and should be replaced with original
equipment belts available from your nearest SEARS
Store or Service Center,
You will need the assistance of a second person white
replacing the belts,.
Drain the gasoline from the fue! tank by removing the fuel
line.i Drain the gas and reinstall fuel line.
.................................
CAUTION: DRAIN THE GASOLINE OUT I
DOORS ' AWAY,FROM FIRE OR FLAME
"i
i _lll • ill ill i .,. ,i -LLI_
AUGER DRIVE BELT
If your snow thrower will not discharge snow, and the
auger drive belt is damaged, replace it as foltows:
• Disconnect the spark plug wire_
o Remove the belt cover (See Fig, 29)
® Remove the auger drive engine putley, Removing
the engine pulley allows you to remove the belt
without removing the belt guides (See Fig. 30)
• Remove plastic cap, cotter pin and washer from the
wormed end of crank assembly (See Fig 24)
o Remove crank assembly from adjusting rod and
slide crank out of the way
® Have someone hold up on the upper handles
Remove the top two bolts (See Fig. 29) holding the
auger housing to the motor mount frame
e The auger housing and motor frame will separate
(pivoting on lower bolts)
NOTE: It may be necessary to slightly loosen the bottom
nuts (See Fig. 29) to get the auger housing and motor
mount to pivot,
e Bend tthe belt retainer tabs (See Fig 3t ) away from
the auger pulley.
• Remove the old auger belt and install new one,.
® Pull up on the belt to hold it firmly in the "V" of the
pulley and bend the belt retainers back into position
leaving t/16 to 1/8 inch clearance between the bett
and the belt retainer tabs,
e Standing on the right side of the snow thrower, puit
up the auger drive belt
• Have someone engage the auger drive lever and
pivot the motor mount frame back into position
NOTE: Engaging the auger dr ve lever moves the auger
brake out of the way.
• Reinstall the top two bolts that hold the auger
housing to the motor mount frame and tighten the
bottom two nuts if they were loosened
e Place the auger drive belt on the engine pulley and
reinstall the auger drive engine pulley
Ill, II, I II I,I I' II III I II II,I II,, I I II,I, I ,llll ,, ' I,,I, IlL •
USTIVlENTS
ADJ ........................
i .N,,, H .i ,,L I
e__ BELTCOVER
1/4 X 1/2 INCH SELF
TAPPING SCREW
% TOP BOLT
BOTTOM NUT
i ill
FIG, 29
i illll i ...........................
TRACTION.... _ TRACTIONDRIVEBELT
DRIVE
BELT TRACKDRIVE
,_ PULLEY
TRACTION-,i-_
IDLERPULLEY
)' BELTGUIDE
AUGER
PULLEY
BRAKE ASSEMBLY
ill.i ii i lll .i i,ill . ii ii i,,,,i i,
FIG. 30
/
1/16 TO 118INCH
CLEARANCE
WITHBELT
FIRMLY IN"V'"
O
AUGER
"_PULLEY
BELT
RETAINER
TABS
FIG. 31
= Adjust drive belt, see To Adjust Belts paragraph on
page 20
e Reinstall the removed parts in reverse order of
removal,
21
Loading ...
Loading ...
Loading ...