Loading ...
Loading ...
Loading ...
STEP2.Removehold-downscrewand
terminalblockcover.
H01d-d0wnscrew
Terminalblockcover
STEP 3. Attach a 3/4-inch, U.L.-listed
strain relief to the hole below terminal
block opening. Strain relief should have
a tight fit with dryer cabinet and be in a
horizontal position. Put the direct wire
cable through the strain relief.
STEP 4. Loosen or remove terminal block
screws. Connect the neutral wire (white
or center) of direct wire cable under the
center screw of the terminal block.
STEP 4a. Place the hook-shaped end
of the wire over the terminal block screw.
The open side of the hook should face
to the right. Squeeze hook end of wire
together to form a loop.
STEP 5. Connect the other two wires
to outer terminal block screws using the
same method(s) described in STEP 4a.
Securely tighten all electrical connections.
STEP 6. Tighten the strain relief screws.
STEP 7. Insert tab of terminal block
cover into slot of the dryer rear panel.
Secure cover with hold-down screw.
If local codes do not permit the
connection of a frame-grounding
conductor to the neutral wire,
see the instructions on page 17.
Otherwise, proceed with installation
on page 23.
External ground
connector
Centersilver-colored
blockscrew
Neutral wire
(white)
Neutralgro0nding
wire(green/yellow)
3/4-inch,&L-listed
strainrelief
3-Wire Connection with Direct Wire
and Frame=Grounding Conductor
I6
Loading ...
Loading ...
Loading ...