Loading ...
Loading ...
Loading ...
Care and Maintenance
Cleaning the Spray Arms
NOTICE
Dirt and/or calcium residue may block the nozzles on the spray arms. for
this reason, regularly check the spray nozzles.
1 Lower spray arm
2 Upper spray arm
• Remove the lower rack from the machine.
• Pull off the lower spray arm in an upward direction A.
• Loosen the fastening screw of the upper spray arm and pull off the
spray arm B by a downward motion.
• Clean the spray arms under running water.
• Replace the lower spray arm in a downward direction.
• Replace the upper spray arm and tighten the fastening screw by
turning it around to the left.
• Insert the lower rack.
38 39
Product Care
Product Care
Troubleshooting
Problem
Possible Cause and/or Remedy
Dishwasher does not
start
Is the machine plugged in?
Are all fuses operative?
Is the water supply fully turned on?
Is the dishwasher door closed securely?
Have you pressed the On/Off button?
Cancel the program by pressing the Start/Pause
button for 5 seconds.
Adjust door tentioners (custom panel models
only, see Installation Guide).
Improper loading:
Load the dishwasher as suggested in this manual.
Insufficient rinse agent supply:
Increase the dosage amount of rinse agent
and/or refill the rinse agent dispenser.
Dishes are removed too soon:
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the
steam can escape. Begin with unloading the
dishwasher when the dishes are only hand warm.
Empty the lower rack first. This prevents water
from dripping off dishes in the upper rack.
Wrong program selection:
In short period programs, the wash temperature
and therefore the cleaning performance is lower.
Choose a program with a longer washing time.
Washing cutlery with worn surface:
Evaporation of water is more difficult with these
items.
Cutlery or dishes of this type are not suited for
dishwashers.
Dishwasher starts but
fails to circulate water
within 5 seconds
Door will not stay
down in open
position
Dishes are not dry
Poor wash results may not always be caused by the dishwasher. Please
review the following Troubleshooting Charts for possible remedies. You
may find the proper solution without having to call a service provider.
Poor Dishwashing Results
CAUTION
Made sure the fastening screw is tight on the upper spray arm.
Check if the holes on the top of the
third spray arm are clogged. If they are
clogged, remove and clean them.
To remove them, slightly push them
upwards (1) and then turn clockwise (2).
To replace the impeller, seat it into its
slot, push slightly upwards and turn it
counter clockwise until it is securely fitted. When the impeller is
released, check if it rotates without any obstruction.
What if the “S:an” is not
displayed on the screen?
Dishwasher cycle was interrupted or the water
did not reach required temperature.
Loading ...
Loading ...
Loading ...