Loading ...
Loading ...
Loading ...
29
Operation
28
Operation
Operating the Dishwasher
• Open the detergent container by pushing the lock to the right A.
• Pour/put the detergent into the dispenser.
• Close the lid until it clicks in.
• The detergent container holds a total of 40 ml/8 tsp. of detergent
• Marking lines on the inside of the detergent container aid in providing the
correct amount of detergent. When the dishwasher is fully loaded and the
dishes are very dirty, we recommend filling the detergent container up to
the 25 ml/5 tsp. mark. When the dishes are less dirty, it is generally
sufficient to fill the detergent up to the 15 ml/3 tsp. mark.
• The detergent amounts for the individual cleaning programs are shown in
the Program Table on page 21.
• Fill amounts given are for standard powder detergent. Amounts may vary if
you use liquid or concentrated power detergent. Tablet detergents should
be placed in detergent container
1 with the cover closed.
• Follow instructions on the package of the detergent when using liquid
dishwasher detergent, concentrated powder detergent, or tablet detergent.
• Deviations are possible depending on how dirty the dishes are and how
hard the water is in your location.
• If your dishes have been in the dishwasher for some time without being
washed, also fill the smaller container
2 up to the top.
A
Operating the Dishwasher
Filling Rinse Agent Dispenser
WARNING
Keep your rinse agents out of the reach of children. Ingestion or inhalation
of rinse agent may cause serious injury. Avoid contact with skin and eyes,
and keep children and people in poor health away from rinse agents.
NOTICE
• Only use rinse agents suitable for use in dishwashers. Rinse aids allow
washing water to rinse off more cleanly and prevent watermarks or
streaks on the dishes.
• If you use “2 in 1” or “3 in 1” detergents/tabs, you do not need
additional rinse agent.
• Open the rinse agent dispenser by
pressing the lock B.
• Carefully pour in rinse agent to the MAX
mark.
• Close the lid until it clicks in
3.
• Carefully wipe off spilled rinse agent.
Excessive rinse agent causes excessive
foam formation, which may hinder
cleaning.
Set the Dose of Rinse Agent
The dose of rinse agent to be used can
be set by means of the dispenser
regulator 4 between levels 1 and 6.
Change the setting, only if the following
applies after washing:
• Watermarks are visible on the dishes: Set
dosage higher.
• Streaks are visible on the dishes: Set
dosage lower.
Loading ...
Loading ...
Loading ...