Loading ...
Loading ...
Loading ...
13
Fireplace Installation
Partial Recessed Installation
- 2x4 Framing
CAUTION: Two people may
be required for various steps
of this procedure.
1. Prepare a wall with a framed
Figure 9
2 x 8 Framing
Figure 10
Mounting hole
Mounting hole
Wall
surface
opening of 30 ½ in. (77.5 cm)
wide x 16 ½ in. (42 cm) high
(Figure 7).
!
NOTE: The sizing has allowed
for ¼ in. (6.4 mm) around the
replace insert for ease of instal-
lation. This replace does not
require any additional venting.
!
NOTE: It is recommended
that the bottom of the unit not be
mounted higher than 40 in.
(102 cm) from the ground to main-
tain an optimized viewing angle of
the ame.
2. Choose your method of sup-
plying power to the unit:
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the replace (rec-
ommended). Follow the hard
wiring instructions on page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: Ensure that the On/
Off Switch is set to the Off position
(refer to Operation section) and that
Loading ...
Loading ...
Loading ...