Loading ...
Loading ...
Loading ...
WATER SUPPLIES
15
SATURATION INDEX
The saturation index is used as a measure of the water’s corrosive or scaling
properties.
In a corrosive water supply, the water can attack copper parts and cause them
to fail. Where the saturation index is less than –1.0, the water is very corrosive
and the Aquamax warranty does not apply to a copper sheathed heating unit. A
corrosion resistant heating unit must be used for the Aquamax warranty to
apply to the heating unit.
In a scaling water supply calcium carbonate is deposited out of the water onto
any hot metallic surface. Where the saturation index exceeds +0.40, the water
is very scaling. An expansion control valve must be fitted on the cold water line
after the non-return valve to protect and for the Aquamax warranty to apply to
the temperature pressure relief valve and water heater cylinder.
Where the saturation index exceeds +0.80, the Aquamax warranty does not
apply to a standard watts density heating unit. A low watts density heating unit
must be used for the Aquamax warranty to apply to the heating unit.
Water which is scaling may be treated with a water softening device to reduce
the saturation index of the water.
Refer to the Saturation Index chart on page 15. Refer to the cold water
connection detail on page 30 for the position of the expansion control valve.
Contact Aquamax Service if a replacement heating unit is required.
+0.4 +0.80-1.0
no warranty applies
to a:
temperature pressure relief valve or
a water heater cylinder unless an
expansion control valve is fitted.
no warranty applies
to a:
-copper sheathed heating unit
SATURATION INDEX (SI)
ELECTRIC WATER HEATERS
WITHIN WARRANTY
SPECIFICATION
SATURATION INDEX
(calculated @ 80°C water temperature)
no warranty applies
to a:
-standard watts density heating unit
very corrosive very scaling
scaling
corrosive
Loading ...
Loading ...
Loading ...