Loading ...
Loading ...
Loading ...
2. Select “Settings” (depending on software version).
3. Select “General”.
4. Select “Bluetooth”.
5. Switch Bluetooth “On” to initiate searching.
6.
Select “Tivoli Bluetooth (Not Paired)” when it appears on the display. If you are prompted
to enter a PIN, enter “0000”. “Tivoli Bluetooth” will change from “Not Paired” to
“Connected”.
7. You will hear a ring tone from the PAL+ and you can begin playing your music files wirelessly.
Adjust the volume level on your device. You should not have to pair your iPhone/iPod/iPad
again.
The volume output level of music files varies. If you prefer an even higher output level,
check the settings in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off,
and the Volume limit Off.
If you encounter a problem Pairing, press the small arrow to the right of “Tivoli Bluetooth” on your
iPhone/iPod touch/iPad display and select “Forget this Device”, then repeat the Pairing process.
Depending on your device, you may need to make multiple attempts at Pairing and/or
Connecting to the PAL+, but please give your device adequate time to Pair or Connect
before repeating the process.
When streaming music, you can press the blue arrow to the right of the next track button
>>/ on the iPhone/iPod touch/iPad display to alternate between the iPhone/iPod/iPad and
Bluetooth.
NOTE:
• The PAL+ will remember pairing information for up to 8 devices. Additional devices
can be paired, but the least-recently used device will be replaced by the newly paired
device.
• If the audio drops out or stops during playback, move your device closer to the PAL+,
or check to be sure another wireless device is not interfering with the signal.
• When switching from Bluetooth to DAB or FM, you may need to re-adjust (lower) the
radio’s volume level.
About the NiMH Battery Pack
The PAL
+
uses a sealed pack of 6 high capacity Nickel Metal Hydride (NiMH) cells. Unlike
Nickel Cadmium (NiCd) batteries, NiMH batteries have no memory effect, provide a longer
operating time, and are not composed of toxic metals. The battery icon on the LCD serves
both as a power and charging indicator.
CHARGING: To charge the battery, plug the PAL
+
in and place it in Standby. From full
discharge, the battery will be completely charged within approximately 3.5 hours. Because
the battery is new, it may take 4-5 full charge/discharge cycles until you experience aver-
age playback performance times. During charging, the battery icon on the LCD will flash.
The battery icon will stop flashing and all 3 bars will be shown on the LCD once the battery
is fully charged. The battery does not charge while the PAL
+
is plugged in and turned on,
but the battery icon will still show the status of the battery. In short, with the PAL
+
plugged in,
place it in standby whenever you want to charge the battery.
16 – ENGLISH
Loading ...
Loading ...
Loading ...