Loading ...
Loading ...
Loading ...
Adjustment
ST'E P I Adjust UP and DOWN Limits
The limit adjustment screws are located on the left side panel of the opener chassis as shown LIMIT ADJ USTMENT
settings regulate the points at which the door will stop when moving up or down
NOTE: DoorSTOPS in UP direction if anything interferes with door travel Door REVERSES in DOWN direc-
tion if anything interferes with door travel (including binding or unbalanced doors),,
PROCEDURE: To operate opener, press Wall Con-
trol Push Button or transmitter push button, Run the
opener through a COMPLETE TRAVEL CYCLE No
adjustments are needed when the door opens and
closes completely and does not reverse uninten*
tionally in down direction
The following chart outlines adjustment procedures.
Run opener through a COMPLETE TRAVEL CYCLE
AFTER EACH ADJUSTMENT. NOTE: REPEATED
OPERATION OFTHE OPENER DURING ADJUST-
MENT PROCEDURES MAY CAUSE THE ,MOTOR
TO OVERHEATAND SHUTOFFo SIMPLYWAIT 15
MINUTES AND TRY AGAIN,, Read the chart care-
fully before proceeding to Step 2, Pg t9 Use a screw-
driver to make limit adjustments
Limit
Adiustment
Screws
Adjustmen_ Label
LliVIlT ADJUSTMENT CHART
IF DOOR DOES NOT
OPEN COMPLETELY
BUT OPENS AT
LEAST FIVE FEET
tF DOOR DOES NOT
CLOSE COMPLETELY
IF DOOR REVERSES
WHEN CLOSING AND
THERE IS NO INTER-
FERENCE TO
TRAVEL CYCLE
Increase UP travel by turning UP LIMIT adjustment screw in
clockwise direction as shown on labe! One turn equals 2
inches of travel,
If door doesn't open at least 5 feet, adjust OPEN FORCE as
explained in Step 2, Page 19
1,, ON SECTIONAL DOORS:
Lengthen the door arm (See Step t0, Page 16)
If door arm is at maximum length, increase the DOWN travel
by turning the down limit adjustment screw in a counter
clockwise direction as shown on label One turn equals 2
inches of travel,
If door still will not close completely, the header bracket is
positioned too high Repeat Step 2, Page 11
2o ON ONE-PIECE DOORS:
Increase DOWN travel by turning the down limit adiustment
screw in a cou nterclockwise direction as shown on label One
turn equals 2 inches of travel
TEST DOOR FOR BINDING
Pull emergency release handle and manually open and close
the door If door is binding, call a door serviceman
t,. IF OPENER REVERSES BEFORE DOOR CLOSES FULLY:
Adjust the CLOSE FORCE as explained in Step 2, Page 19
2, IF OPENER REVERSES IN FULLY CLOSED POSITION:
Decrease DOWN travel Turn the down limit adjustment screw
in clockwise direction One turn equals 2 inches of travel
t8
Loading ...
Loading ...
Loading ...