Loading ...
Loading ...
Loading ...
installation
Completed installations of header bracket, door bracket and door arm (depending on door type) are shown below, The
header bracket supports the front end of the Tee rail. The door bracket connects door arm to trolley
IT iS RECOMMENDED THAT THE OPENER BE INSTALLED 7 FEET OR MORE ABOVE THE FLOOR WHERE SPACE
PERMITS Follow only those instructions which appty to your door type as shown on Page 5.
STE P ! t.sta. oorBraoket Plate
TO PREVE NT'DAM'AGE'TOL|G HTWEIGHT GARAGE DOORS','ALwAYS REINFoRcETHEINsiDE O'FDOOR_
BOTH VERTICALLY AND HORIZONTALLY--WITH 2x4 BOARDS OR ANGLE IRON,
Horizontal brace should be at least 6 feet long, Vertical brace should cover height of top panel. Reinforcement
hardware is not supplied (See No t Below) FASTEN SECURELY AS SHOWN BEFORE INSTALLING DOOR
BRACKET AND PLATE.
Sectional Door installation Procedure
With door closed, locate and mark the vertical center-
line of garage door Extend line onto header wall
above door
Header
8rackel
1
Header
Vertical Wall
Center--
Line t
Door Bracket &
Plate Assy
DOOr
Arm
Board for
Lightweight Doors
SECTIONAL DOOR
t, Assemble door bracket and plate as shown Cen-
ter bracket on vertical guideline (or up to one foot left
or right of center if necessary)
2. Position bracket assembly on face of door within
the following limits: A,, Top edge of bracket 2" to 4"
below the top edge of door B.. Directly below any
structural support across top of door
Placement depends on your particular needs
3o Mark and drill 5/16" TOP and BOTTOM fastening
holes Secure bracket as shown
Inside Edge
of Door or Nul ,--"
Reinforcement Board 5/16"-18
All One-Piece Door Bnstailation Procedure
With door closed, locate and mark vertical centeriine
of door Extend line onto header walt above door
NOTE: The door bracket has left and right side
fastening holes. Assemble door bracket and plate
if your installation requires top and bottom fas-
tening holes,, (Refer to illustration).,
Center bracket (with or without plate as required) on
top edge of door as shown Mark and driti two 5/16"
fastening holes and secure door bracket, NOTE: If
door has no exposed framing, drill 3/16" pilot
holes and substitute 5/16" x 1-1/2" lag screws
(not supplied) to fasten bracket to top of door.
Lock Washer _/NuI
5/16" _ 5/16"-18
Top Edge
of
(Outside) -(Optional)
I Carriage Bolt
i F 5116'-18x2-1/2 "
NOTE: Door bracket may be installed on face of
door if required for your installation, (Refer to
dotted line drawing). HOWEVER, drill 3/16"pilot
holes and substitute 5/16"× 1-1/2" lag screws
(not supplied) to fasten bracket to door.
Header
Bracket
Door
8racket
1
Door
Arm
Face of Door
Installation
Vertical
Cen
Line
ONE PIECE DOOR
1
Header
Wall
Door Braeke
Plate
(Optional)
lO
Loading ...
Loading ...
Loading ...