Loading ...
Loading ...
Loading ...
Bnstantation
TO AVOID SERIOUS PERSONAL IN JURY FROM ENTANGLEM ENT, REMOVE ALL ROPES CON NECTED TO THE
GARAGE DOOR BEFORE OPERATING DOOR OPENER°
REMOVE EXISTING GARAGE DOOR LOCKS OR USE A WOOD SCREW OR NAIL TO MAKE THEM |NOPERATIME.
INSTALLATION AND WIRING MUST BE IN COMPLIANCE WITH LOCAL BUILDING AND ELECTRICAL CODES°
OPERATION AT OTHER THAN 120V 6OHz WILL CAUSE OPENER MALFUNCTION AND DAMAGE.
IF LOCAL ELECTRICAL CODES DO NOT REQUIRE
PERMANENTWIRING: Insert the 3-prong plug into a
3-hole receptacle. UNIT MUST BE GROUNDED DO
NOT USE A 2-WIRE ADAPTER.,
IF LOCAL CODES REQUIRE PERMANENTWlRING:
Refer to illustration,
PROCEDURE: Make connection through 7/8 inch
diameter hole in top of opener chassis
1. Remove opener chassis cover by removing the 4
cover screws,
2, Remove attached 3-prong cord.
3. Connect black (line) wire to black wire on terminal
block; white (neutral) wire to white terminal wire; green
(ground) wire to green ground screw.
CAUTION: BE SURE UNIT IS GROUNDED
ACCORDING TO LOCAL CODE
Ground Tab
Ground Screw
While
Wire
STEP 9 l.sta,Lights andLenses
PROCEDURE: Install a 75 watt maximum light bulb
in each socket as shown The iights turn on automati-
cally when opener starts. After 4-t/2 minutes they
wilt turn off, Lights will REMAIN ON when Work Light
push button on Wail Control is pressed.
IMPORTANT NOTE: if the lights in your _tarage
door opener do not work_ it may NOT be the fault o f
the opener. Some short-neck bulbs, because of
their shape, do not make contact with the socket
base tab,, Use standard-neck bulbs,
INSTALLING LENSES: Slide lenses into the lens
guides as shown_ Snap bottom tabs into tens slots.
(The force and limit adjustment settings are located
on side panels behind lenses)
NOTE: FOR CONVENtENCE_ LENSES MAYBE IN-
STALLED AFTER ADJUSTMENT, STEP 3, PAGE 20.
Lens Tab
Lens
Slot
Lens
Guide
15
Loading ...
Loading ...
Loading ...