Loading ...
Loading ...
Loading ...
E.
i .,,pl,ii i,,i., . ,,, Hill II I JI II
[111 I I 1,,,,,,,,I,, • " H..H .11 I I m IIIIIIIIIIIII
IIIIIIIIIIIIIII III I I I I
AIR FILTER
• A dirty air filten
reduces cutting power
-- increases fuel consumption
• Clean the Air Filter:.
--frequently, especially under very dusty
conditions.
--always after 10 tanks of fuel mixture or 5
hours of operation whichever is less.
t. Clean off the carburetor cover and the area
around it to keep dirt and sawdust from falling
into the carburetor chamber when the cover is
removed.
2. Remove the carburetor cover screws and car*
buretor cover. Figure 45,
3. Pull out the air filter.
4. Wash the filter in soap and water.
Never operate the unit without the air
filter in place to avoid damage tothe engine.
I CAUT|ON: j Do not use gasoline or other flam-
mable liquid to clean the filter to avoid creating
a fire hazard.
Figure45
5. Squeeze the filter dry.
6. Add a small amount of oil to coat the filter.
NOTE: Avoid soaking the filter with oil.
7. Squeeze out excess oil.
8. Replace filter by tucking in edges and
smoothing it llush with the carburetor housing.
NOTE: Be careful when replacing the car-
buretor cover as incorrect placement will pre-
vent the choke from working properly,
,,, ;' / /,;;; : _-.......
9. Move the choke knob all the way tolhe right.
10. Check the choke shuttertobe sure it isclosed.
Figure 45.
11. Reinstall the carburetor cover and tighten the
carburetor"cover screws.
12. Check the operation of the choke.
NOTE: tf the choke knobsticksor will not move,
remove the cover and repeat steps 9-12 above.
....i ii iiiiiiiiiiiiiiii ii iii ii iiiiiiiii i i i II II I i_
F. sTORAGE
When your saw is to be stored for over 30 days,
always:
0rain fuellank sna safe man net,(See FuelingYour
Engine".)
2. Starl engine and allOW to run at idle
sp_ed until th_ engine stops.
NOTE: This will remove most of the fuel from
the fuel system.
3. Drain oil tank.
ICAUTION:j Wear protective gloves when han-
dling the chain. The chain is sharp and can
cul you even when it is not moving.
I Ii iiiiiiii I i
.... i,
.... j[i ii i i
NOTES
4. Remove, clean, and dry the bar and chain.
5. Store the chain in a container filled with of!
tO prevent rust,
6. Apply a coating of oil to the entire surface of
the bar and wrap it in heavy paper, cloth or
plasti'c.
7. Clean the outside surfaces of the engine.
8. Store the saw in a dry place, out of the reach
of children, and away from where fuel vapors
can reach open flames from hot water heater,
furnaces, etc.
.v, •
2O
Loading ...
Loading ...
Loading ...