Loading ...
Loading ...
Loading ...
Positioning and connecting en
31
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
■ The washing machine must be
correctly installed and connected
~ Page 26
■ Never use a damaged machine.
Inform customer services.
1. Check the machine.
2. Remove the protective film from the
control panel.
3. Connect the mains plug.
4. Turn on the tap.
5. Close the door (do not load any
laundry).
6. Depending on the model, run the
Drum Clean 90 °C or
Cottons 90 °C program. For AU
variant, two cycles of Cottons 90 °C
programme without laundry are
required to be run at initial setup,
and this operation only needs to be
completed once.
7. Open the detergent drawer.
8. Pour approximately 1 litre of water
into compartment II.
9. Pour standard detergent into
compartment II.
Note: To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for wool or delicates.
10.Close the detergent drawer.
11.Press the ‹ button.
12.When the program ends, switch off
the appliance.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1. Turn off the water tap.
2. Reduce the water pressure in the
supply hose.
Maintenance – filter in the water
supply
~ Page 22
3. Drain the remaining detergent
solution.
Maintenance – detergent solution
pump blocked
~ Page 20
4. Disconnect the washing machine
from the mains.
5. Remove the hoses.
Installing the transport locks:
1. Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2. Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
■ The transport braces must be
removed.
■ To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the Spin/Drain program.
Loading ...