Loading ...
Loading ...
Loading ...
Programme default settings en
13
0 Programme default
settings
Programme default settings
Note: You can find possible
programme default settings in the
overview; these differ depending on the
model.
The programme default settings for all
programmes are preset at the factory
and are displayed in the display panel
after the programme is selected.
Temperature
(°C, Temp. °C)
Depending on what stage the program
is in, you can change the set
temperature before and during the
program.
The maximum temperature that can be
set depends on the program that has
been selected.
0 rpm
(0, Spin speed)
Depending on what stage the program
is in, you can change the spin speed (in
rpm; revolutions per minute) before and
during the program.
Setting 0: The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting - - - -: (Rinse Stop) = no final
spin. The laundry stays in the water after
the final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To continue/end the program
~ Page 18
The maximum speed that can be set
depends on the model and program
that has been selected.
û Finish in
(û, Finish in time)
Before starting the program, you can
preselect the program end ("Finish in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
1. Select a program.
The program duration is displayed
for the selected program, e.g. 2:30h
(hours:minutes).
2. Press the û Finish in button
repeatedly until the required number
of hours is displayed.
3. Press the ‹ button.
The program starts.
The selected number of hours (e.g.
8 h) is shown in the display panel
and counts down until the wash
program starts. The duration of the
program is then displayed.
Note: The length of the program is
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
■ Program settings,
■ Detergent dosage (additional rinse
cycles if required due to foaming),
■ Load size/type of textiles (water
absorption differs),
■ Imbalances (e. g. due to fitted
sheets) are offset with several start-
ups of spin cycles,
■ Fluctuations in power supply,
■ Water pressure (infeeding speed).
Following the start of the program, you
can change the preselected number of
hours as follows:
1. Press the ‹ button.
2. Use the û Finish in button to
change the number of hours.
3. Press the ‹ button.
Following the start of the program you
can add or remove laundry as required.
Loading ...
Loading ...
Loading ...