Loading ...
Loading ...
Loading ...
40
BURNERS
■ They can be removed and washed only with soapy water.
Detergents can be used but must not be abrasive or corrosive.
Do not use abrasive sponges or pads. Do not put in dishwasher.
■ After each cleaning, make sure that the burner-caps, as well as the burners, have
been well wiped off and CORRECTLY POSITIONED.
■ Check that the electrode “S” (gs. 42a, 43a, 44a) next to each burner is always clean
to ensure trouble-free sparking.
■ Check that the probe “T” (gs. 42a, 43a, 44a) next to each burner is always clean to
ensure correct operation of the safety valves.
Note: Both the probe and ignition electrode must be very carefully cleaned.
To avoid damage to the electric ignition do not use it when the burners are not in
place.
AUXILIARY AND SEMI-RAPID BURNERS
It is essential to check that the burner ame distributor “F” and the cap “C” have been
correctly positioned (see gs. 42a - 42b) - failure to do so can cause serious problems.
TRIPLE RING BURNER
The triple ring burner must be correctly positioned (gs. 43a - 43c); the burner rib must be
located in position as shown by the arrow (g. 43a).
The burner correctly positioned must not rotate (g. 43b).
Then position the cap “A” and the ring “B” (gs. 43b - 43c).
DUAL BURNER
The dual burner must be correctly positioned (see gs. 44a - 44c); the burner rib must be
tted as shown by the arrows.
The burner correctly positioned must not rotate.
Position the central small cap in its housing as shown by the arrows (g. 44b).
Position the big cap in its housing as shown by the arrows (g. 44c).
IMPORTANT: NEVER unscrew the burner screws (g. 44d).
Loading ...
Loading ...
Loading ...