Loading ...
Loading ...
Loading ...
III ?R"=:ilu III °°°
MAINTENANCE
5. Remove the high pressure nozzle from the wand
and instal[ the black injection nozzle. The
solution will automatically mix with the
water and discharge through the nozzle.
NOTE: For certain models, if the engine throttle
is not in the fast position, the injection of the
solution may be decreased or stopped.
1
CLEANING TECHNIQUES
Cleaning Techniques
When cleaning with the pressure washer, many
cleaning tasks can be solved with water alone, but
for most tasks, it is advantageous to use a
detergent also. A detergent ensures a quick
soaking of the dirt allowing the high pressure water
to penetrate and remove the dirt more effectively.
APPLICATION OF SOAP OR DEGREASER
1. Apply the solution to a DRYwork surface.
On a vertical surface, apply horizontally from side
to side starting from the bottom to avoid streaking.
NOTE: Wetting the surface first is not
recommended, it dilutes the detergent and
reduces its cleaning effects.
Avoid working on hot surfaces or in direct sunlight
to minimize the chances of the chemical damaging
painted surfaces. Damage may occur to painted
surface if chemical is allowed to dry on the
surface. Hold nozzle far enough away from
surface to prevent damage to the surface.
2. Allow chemical to remain on the surface for a
short time before rinsing.
3. Rinse with clean water under high pressure. On
a vertical surface, first rinse from the bottom up,
then rinse from the top down. Hold nozzle 6 to 8
inches from the work surface at a 45 ° angle using
the flat spray as a peeling toot rather than a scrub
brush.
APPLICATION OF WAX
1. Immediately after cleaning, apply wax. Place
injection tube in container of wax.
2. Apply the wax sparingly in an even layer. Apply
to wet surfaces from bottom up for even
distribution and to avoid streaking.
3. Remove the suction tube from the wax bottle
rinse off the surplus wax.
NOTE: IF SURPLUS WAX IS NOT REMOVED, A HAZY
FINISH MAY RESULT.
4. Wipe dry to reduce water spotting.
END OF OPERATION
End of Operation
When you have completed use of the chemical
injection system, remove tube from container.
Continue to run in tow pressure position and
inject clean water through the tube and
injection system by placing end of tube in a
container of clean water. Continue to run until
it is thoroughly cleaned.
MAINTENANCE
CONNECTIONS
Connection on pressure washer hoses, gun and
spray wand should be cleaned regularly and
lubricated with the manufacturer's recommended
grease to prevent leakage and damage to the
o-rings.
NOZZLE
Clogging of the nozzle causes the pump pressure
to be too high and cleaning is immediately
required.
A nozzle cleaner must only be used when the
spray wand is disconnected from the gun or
personal injury could be occur
1. Separate the wand from the gun.
2. Clear the nozzle with a small rigid piece of wire
such as a paper clip.
3. Flush the nozzle backwards with water.
4. Reconnect the wand to the gun.
Restart the pressure washer and depress the
trigger on the spray gun. If the nozzle is stilt
plugged or partially plugged, repeat above
instructions 1-4.
If the previous procedure does not clear the
nozzle, replace with a new nozzle.
WATER SCREEN
The pressure washer is equiped with a water inlet
screen to protect the pump. If the screen is not
kept clean, it wilt restrict the flow of water to the
pressure washer and may cause damage to the
pump. Do not damage the screen white removing
or cleaning screen. Any foreign particles entering
the pump may damage the pump. Do not operate
pressure washer without the screen in place.
Remove the screen and backflush to remove
impurities from screen. Replace immediately.
Loading ...
Loading ...
Loading ...