Loading ...
Loading ...
GENERALPRECAUTIONS
• Do not touch the nozzte or water spray white
operating.
• Wear safety goggtes white operating.
• Only approved hoses and nozzles shoutd
be used.
• Do not kink the high pressure hose.
• A[t hose connections must be property seated.
• Prior to starting the pressure washer in
cow weather, be sure ice has not formed in
any part of the equipment.
• Use onty recommended chemicals.
• Outdoor use onty.
• Ptace the pressure washer away from
cleaning site during operation.
• To prevent accidentat discharge, the spray
gun shoutd be secured by rocking trigger
when not in use.
• Do not run the pressure washer for more
than five minutes without depressing the
trigger or damage to the pump may resutt.
• Check the fuel system periodicatty for teaks
or signs of deterioration such as chafed or
spongy hose, loose or missing damps, or
damaged tank or cap. Art defects shoutd be
corrected before operation.
• Do not touch hot muffler.
• Service, operate and refuet under the
for[owing conditions:
a. Good ventitation.
b. Refuet the pressure washer in a weft
righted area.
c. Avoid fuet splits and never refuel white
the pressure washer is operating.
d. Avoid an ignition source when refueling.
e. Use read free fuet with a minimum of
85 octane.
• Do not smoke near the pressure washer.
• Do not use damaged high pressure hoses.
SAFETY FEATURES
THERMAL RELIEF VALVE
A thermat retief vatve is provided to protect
the pump from overheating if the spray gun is ctosed
for an extended tength of time or the nozzte becomes
ptugged. However, it is intended to be used as a
backup system and every effort shoutd be made to
not permit the pump to heat up.
We recommend turning the pressure washer off if it
witt not be used for more than five minutes. This
saves wear on the unit, reduces fuel consumption and
extends the rife of the pump by avoiding heat.
SAFETY LOCK OFF LATCH
To prevent accidentat discharge of high pressure
water, the safety tatch on the trigger should be
engaged whenever the pressure washer is not in use.
LOW-OIL SHUTDOWN
Some engines are equipped with tow-oit shutdown. If
the engine oit [ever becomes tower than required, the
pressure washer witt automatica[ty shut off. (Refer to
the engine manuat for this feature). This protects
your pressure washer engine from operating without
proper [ubrication.
If the pressure washer engine shuts off and the oi[
fever is according to specification, check to see if the
pressure washer is sitting at an angte that forces oit
to shift. Prate on an even surface to correct this. If
the engine fairs to start, the oi[ [eve[ may not be
sufficient to deactivate tow oi[ [ever switch. Be sure
the pumpis comptetety fur[ of oit.
The pump witt overheat and may damaged, or
cause damage if allowed to circutate more than
five minutes.
BEFORE OPERATION
NOTE: The engine and pump on your pressure washer
witt often have improved performance after a
break-in period of severat hours.
PRE-START PREPARATION
Before starting the pressure washer, check for toose
or missing parts and for any damage which may have
occurred during shipment.
Loading ...
Loading ...
Loading ...