Loading ...
Loading ...
Loading ...
I
1. Installing the right and left hooks
a) Install the left hook using the bolts, nuts, and washers supplied (see Figure 1)
b. Install the right hook using the bolts, nuts, and washers supplied (see Figure 2)
2, Insta{ling the wheels
I ) HoW the _ocating pin in the wheel set backward _n herizonta_ [eve[ and press the locating p_n into
supporting'tube unt_t the dick _sheard_ which _ndtcates the p_n clutches at the supporting tube
(see Fi_. 3),
2) Until the p_n is higher than the thickness of supporting wall (see F_, 4).
START-UP PROCEDURE
PR£-START PREPARATION
Before starting the pressure washer, check for
loose or missing parts and for any damage wMch
may have occurred during sh_pment_
PUMP PREPARATION
The pump _ssh_pped with a shlpp_n_ p_ug, this
writ need to be replaced with the vent ptug that
START-UP PROCEDURE
1.Make sure water supp[y _sconnected and
turned on.
2_ Re[ease gun safety if locked.
3_ To aUow air to escape from the hose. squeeze
tr_er on the gun until there is a steady f[owof
water coming from the. nozz{e.
4. Remove any dirt or _oreign matter from _he gun
out_et and the male connector of the wand.
5. insert the nozzle wand _nto the _un wand and
rig hten the fStting securely.
6 Place the throt[e _n the HI posit_on.
STARTING ENGINE
I) Check oil and gas
2) Connect hose & turn on water
3) Squeeze trigger
4) Make sure pressure washer is on t_e on position
5) Set gas lever to open
6J Set choke if available & set throttle to _as_
7]When starting engine, pull _ord slowly until
resistance is felt, & then pull rapidly to avoid
ki[k back
8) If engine starts & fails to continue to r_n or if
i_rease resistance is felt during starting pull
attempts repeat steps 3
SPRAY NOZZLE SELECTION
Fo[towtng information concermng the four
nozztes provided with your pressure washer, (If
four nozzles are provided,)
NOTE: The force of the spray o_the surface you
are c|ean_ng increases as you move closer to the
surface.
0": H_gh Pressure {Red) : The water stream
dfscharged is very aggressJveo Use with extreme
caution to prevent damage to the surface being
c_eaned or injury to persons or an_ma(s.
15":High Pressure {Ye[[ow_: This is the nozzle
used for most c|ean_ng applications. /t provides
w_de coverage and a powerfut water stream.
25":High Pressure _Green _: This is, the nozzle
used for most c{ean_ng applications. It provides
w_de coverage and a powerfut water s[ream.
45":H_gh Pressure _White}: This is [he nozz[e
used for c{eanin8 w_th a w_der coverage over a
larger area w_th a powerful water stream.
Soap; Low Pressure(B[ack): Provides tower
pressure spray for a wider coverage. Used
primarily whe_ operating the chemical in_ector
to apply chemicals.
14
Loading ...
Loading ...