Loading ...
Loading ...
Loading ...
en
4
WARNING
Excessive Weight Hazard
Use two or more people to move and install range
hood.
Failure to do so can result in back or other injury.
This appliance must be installed by a qualified professional in accordance with the current regulations in the
country where the appliance is installed.
All installation and connection operations, activation and repairs must imperatively be performed by a qualified
technician. The technician will determine the type of wall mounting and the outer ventilation outlet connection
adapted to your hood model.
Take account of the hood’s weight and the support structure’s technical characteristics when choosing the type of
wall mounting. Respect the permitted maximum load values for the supplied pegs. They have the following val-
ues depending on the type of support structure (10mm-diameter pegs):
- Concrete: 9,4 kN,
- Bricks: 5,2 kN,
- Sand-line briks: 4.8 kN.
For any other support structures, please ask the opinion of a building expert (e.g. architect) to guarantee correct
and stable hood assembly.
Incorrect assembly may cause the hood to become loose and the appliance could fall.
Certain parts of the hood may present sharp edges due to production. To protect your hands, wear safety gloves
during installation.
The electrical supply voltage must correspond to the voltage indicated on the rating plate situated inside the
hood near the filters.
Connect the hood to an electrical supply which must be connected to earth and equipped with a circuit breaker
in accordance with the current regulations. The electrical supply must be freely accessible to the power circuit to
interrupt during maintenance in case of maintenance.
In the case of a direct connection to the network, only a qualified electrician may connect the hood to the elec-
tric current. In this case, the electrician must connect the hood to a single-phase alternating current circuit
equipped with a bipolar differential switch.
WARNINGS
2. Risk of injury!
3. Danger of electric shock
1. Installation
Observe all governing codes and ordinances.
Ensure that the electrical installation is adequate and in conformance with
National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards
C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.o-M91 (latest
edition) and all local codes and ordinances.
If codes permit and a separate ground wire is used, it is recommended that
a qualified electrician determine that the ground path is adequate.
A copy of the above standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
♦
A 120 volt, 60Hz., AC only, 15-amp, fused electrical circuit is re-
quired.
♦
If the house has aluminum wiring, follow the procedure below:
1. Connect a section of solid copper wire to the pigtail
leads.
2. Connect the aluminum wiring to the added section of cop-
per wire using special connectors and/or tools designed and UL
listed for joining copper to aluminum.
Follow the electrical connector manufacturer’s recommended pro-
cedure. Aluminum/copper connection must conform with local
codes and industry accepted wiring practices.
♦
Wire sizes and connections must conform with the rating of the
appliance as specified on the model/serial rating plate. The
model/serial plate is located behind the filter on the rear wall of
the range hood.
♦
Wire sizes must conform to the requirements of the National
Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Stan-
dards C22. 1-94, Canadian Electrical Code, Part 1 and C22.2
No. 0-M91 (latest edition) and all local codes and ordinances.
Loading ...
Loading ...
Loading ...