Loading ...
Loading ...
Loading ...
AND ADJUSTMENT
21. Mower Installation
Your Mower installs without the use of tools, Raise At _
tachment Lift Lever (Fig. 28) to its highest position. Turn
height adjustment knob to lowest position (Fig. 29).
a. Slide Mower under tractor, discharge guard to
R.H. Side.
b, Install front hinge pin through axle and parallel
link (Fig, 30). Secure with retainer spring
c, Install rear hinge pin through mower rift
brackets and parallel link (Fig 30) Secure with
retainer spring,
d. Install clutch rod in clutch lever (Fig. 30)-
e , Move Attachment lift lever (Fig, 28) forward
to lower suspension arms, Slide trunnions
through lift bracket holes and secure with re-
tainer springs (Fig,. 27)
f Roll belt over engine pulley. Make sure belt is
inside belt guides (Fig 29). See belt drive
schematic decal on mower housing
g. Use Attachment lift lever (Fig. 28) to raise
mower
h . Turn height adjustment knob clockwise (F'_)
to the middle of its travel, or to desired cut
height (Fig, 29)_
22. Mower Drive Belt Removal
NOTE: MOWER BELT INSTALLATION DECAL
LOCATED ON MOWER HOUSING.
REPLACE ONLY WITH THE BELTS SPECIFIED IN THIS
MANUAL
a • Place attachment clutch lever in "Disengaged"
position (Fig 28)
b Turn height adjustment knob to lowest posi-
tion. Move Attachment lift lever (Fig° 28) for-
ward to lower mower to its lowest position,
c Roll belt off engine pulley (Fig, 29),
d. Pull belt off both mower deck pulleys.,
e • Spring belt guide away from idler pulley and pull
belt off idler pulley.
f. Slide belt from under extension spring,
ATTACHMENT
CLUTCH LEVER
"'DISENGAGED
POSITION"
\
CLUTCH
ROD
LtFT LEVER
UNGER LiFT LEVER
"HIGHEST'
POSiTiON
LiFT LEVER
LOWEST'
I POSITION
ENGINE
PULLEY
FIGURE 29
FIGURE30
21
Loading ...
Loading ...
Loading ...