Loading ...
Loading ...
Loading ...
ADJUSTMENT
! _ BE SURE THERE ARE""NO FUEL 'LINE !
LEAKS AND THAT HOSE CLAMPS ARE
!
• PROPERLY INSTALLED° ,................
16o Replace In-Line Fuel Filter
If fuel filter is clogged, obstructing fuel flow to car-
buretor, replacement is required.
ao With engine cool, remove filter and plug fuel line
sections which were removed fromboth ends offuelfilter
(Fig. 20)_
b. Place new fuel filter in position in fuel line
T 7. Motion Drive Belt Removal
The tractor drive belt may be replaced without tools. Park
the tractor on level area, Engage parking brake. NOTE:
A BELT INSTALLATION DECAL IS UNDER LEFT
FOOTREST
a_ Remove mower, (See page 20),
b, Remove two retainer springs from belt guide
bracket below transaxle pulley_ Remove
bracket (Fig 22).
c, Swing belt guides away from belt, toward rear
of tractor (Fig, 22),
d Roll belt over top of transaxte pulley.
e Roll belt over engine pulley and off idler (Fig.,
23).
f Release parking brake, Pull belt as far as possi-
ble over top of clutch pulley,
g Reset parking brake_ Pull belt over top of
clutch pulley (Fig° 23),
h, Pull belt out through shift gate to remove from
tractor (Fig, 24)°
Install belt by reversing above procedure
NOTE: REPLACE ONLY WITH BELT LISTED IN MANUAL
t, BELT
\\ oo,oE-..
\ TRANSAXLE
7 f I •
RETAINER BELT GUIDE RETAINER
SPR1NG BRACKET SPRING
FIGURE2 2
CLUTCH
PULLEY
ENGINE
PULLEY /
DRIVE BELT
INSTALLATION
DECAL
L H SIDE
BELT GUIDE
REAR
VIEWED FROM BOTTOM OF TRACTOR
FIGURE 23
BELT
SHIFT GATE
FIGURE 24
19
Loading ...
Loading ...
Loading ...