Loading ...
Loading ...
Loading ...
ADJUSTMENT
\
18. Fuse Replacement
Replace with 30 amp automotive - type plug-in fuse, The
fuse holder is located under the dash.
1 9o Hood Removal
a, To raise hood, lift at rear of hood.
b_
C
To remove hood, grill and side panels, raise
hood and loosen one screw on each side panel.
(This screw remains in the side panel) (Fig,, 25),
Unsnap headlight connection (Fig. 26)_
d_ Stand in front of tractor, Grasp hood and tilt
forward and lift off (Fig 26),
SCREW
e • To reinstall, reverse above procedure_
2 O. Mower Removal
FIGURE25
a Remove mower belt per instructions under
"'Mower Drive Belt Removal" through step(c)
HEAOLIGHT
CONNECTION
\
\
b, Remove retainer spring from clutch rod; pull
clutch rod out of clutch bracket. (Fig 27)
c Pull retainer springs out of rear suspension trun-
nions, Remove rear suspension trunnions from
lift brackets (Fig° 27),
d, Pull retainer spring out of rear hinge pin,
Remove rear hinge pin, (Fig_ 27)
FIGURE26 _,'k
RH.
SUSPENSION
RETAINER ARM RETAINER
SPRING t SPRINGS
REAR/ ] - .,,N.#E
SUSPENSION ]
TRUNNIONS
LIFT
BRACKET
NOTE:
e, Pull retainer spring out of front hinge pin_
Remove front hinge pin (Fig, 27),
f. Use lift lever to raise suspension arms, Slide
mower out from under tractor,
IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE
TRACTOR, THE LH. AND R.H. SUSPENSION
ARMS ( FIGo27) SHOULD BEREMOVED FROM
TRACTOR_
FnGURE27
20
Loading ...
Loading ...
Loading ...