Loading ...
Loading ...
Loading ...
Avoid Service Checklist Before you call for service, review this list. It may save you time and
expense. The list includes common occurrences that are not the result of
defective workmanship or materials in this appliance.
OCCURRENCE
This oven is equipped with a state of the art electronic oven controller,
Among its many features is a full time oven circuit diagnostics system. The
controller constantly monitors its internal circuitry aswell as several crucial
oven circuits to insure they are all operating correctly. If at any time one of
these systems fails, the controller will immediately stop operation and
being beeping and flashing an error code of F1 or F3* in the display
window.
POSSIBLE CAUSE/SOLUTION
Range is not level.
Poor installation. Place oven rack in center of oven. Place a level on the oven rack,
Adjust leveling legs at base of range until the oven rack is level.
Besure floor is level and isstrong and stable enough to adequately support range.
If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are
square and have sufficient room for range clearance.
Cannot move appliance easily. Appliance Cabinets not square or are built in too tightly. Contact builder or installer to make
must be accessible for service, appliance accessible.
Carpet interferes with range. Provide sufficient space so range can be lifted over
carpet.
*Oven control beeps and displays F1 or Electronic control has detected a fault condition. Push CANCEL to clear the display
F3. and stop the beeping. Reprogram oven. If fault recurs, record fault number, push
CANCEL and contact an authorized Sears servicer.
Incorrect control setting. Make sure the correct control is on for the surface unit to
Surface unit too hot or not hot enough, be used.
Surface unit does not heat. Lightweight or warped pans used. Use only flat, evenly balanced, medium or
heavyweight cookware. Flat pans heat better than warped pans. Cookware
materials and weight of the material affect heating. Heavy- and medium-weight
pans heat evenly. Because lightweight pans heat unevenly, foods may burn easily.
No power to the appliance, Check steps under "Entire Appliance Does Not Operate"
in this Avoid Service Checklist.
Incorrect control setting. Make sure the correct control is on for the surface unit to
be used.
Entire appliance does not operate. Make sure cord/plug isplugged tightly into outlet.
Service wiring is not complete. Contact your dealer, installing agent or authorized
servicer.
Power outage. Check house lights to be sure. Call your local electric company for
service.
Cooktop and/or oven light (some Replace or tighten bulb. See Changing Cooktop and/or Oven Lights (some
models) does not work. models) in this Owner's Guide for instructions.
rtl
Z
i
21
Loading ...
Loading ...
Loading ...