GE - General Electric PLD621RTSS User Manual

Loading ...

49-2001047 Rev. 3 21

Installation Instructions

INSTALLATION INSTRUCTIONS

6. REPLACE COOKTOP

Place the cooktop back into position and attach

withthe4screws,removedinStep1,usinga

Phillips screwdriver.

7. TEST COOKTOP BURNERS

■ Push and turn the appropriate burner control

knob counterclockwise to the HI position.

■ Turn the ignition knob clockwise continuously

until the burner is lit.

If air is in the supply line, it may take up to a

minute for the air to purge and the burner to

light.

■ The flame may burn yellow for a few seconds,

then it should turn blue. If the burner continues

to burn mostly or completely yellow, see

“Troubleshooting”orcontactaqualifiedservice

technician.

■ Rotate the burner control knob to LO. Make

sure that the flame completely surrounds the

burner. There should be a flame at the burner

ports and no air gap between the flame and

the burner. If the burner does not meet this

criteria, see “Troubleshooting” or contact a

qualifiedservicetechnician.

■ Repeat these steps to test each burner.

8. TEST OVEN BURNER

■ Pull the oven handle to open the door.

■ Push and turn the oven control knob

counterclockwise to the position.

■ Keep the oven control knob pressed and rotate

the ignition knob clockwise continuously until

the oven pilot is lit. The oven pilot is located at

the rear right of the bake burner and is visible

from the front of the oven. If air is in the supply

line, it may take over a minute for the air to

purge and the oven pilot to light.

■ Once the oven pilot is lit, keep the oven control

knobpressedforatleast15secondsuntilthe

oven pilot sensor becomes heated.

■ Release oven control knob and visually confirm

oven pilot remains lit. If oven pilot goes out,

repeat bullets 3 and 4.

■ Rotate the oven control knob to each

temperature and inspect the burner flame. If

the flame is completely or mostly yellow, see

“Troubleshooting”orcontactaqualifiedservice

technician.

9. FLAME QUALITY

The burner flames for the cooktop and bake

burners should be blue with yellow tips. Long,

brightyellowflamesarenotnormal.Normal

flames may show signs of an orange tint when

well heated or signs of flickering orange due to

particles in the gas or air.

Turn burner control

knob counterclockwise

Loading ...

GE - General Electric PLD621RTSS GE Profile 21" Drop-In RV Gas Range

User Manual - Page 21