Loading ...
Loading ...
iMPORTANTSAFETYiNFORMATiON.
READALL iNSTRUCTiONSBEFOREUSING.
A WARNING! Foryoursafe theinformationinthismanualmustbefollowedtominimizetheriskof
electric shock, property damage or personal injury.
SAFETYPRECAUTIONS
• Check and comply with your state and local codes.
You must fi)llow these guidelines.
• Use care when handling tile water softening system.
Do not turn upside dox_l_,drop, drag, or set on sharp
protrusions.
• Water softening systems using so_fium chloride (salt)
for regeneration add sodium to the water. Persons on
sodiumrestricted diets shouldconsider the addedsodium
as part of their overall intake.Potassiumchloride can be
usedas analternative to sodiumchloride in your softener
• Tile water softening system works on 94 voh-60 Hz
ele(uical power only. Be sure to use onlythe included
transformer
• Transformer must be plugged into an indoor
120volt, grounded outlet only.
• Use clean water softening salts only, at least 99.5%
pure. NUGGET, PEI,I,ET or coarse SOLAR salts are
recommended. Do not use rock, block, granulated
or ice cream making salts. They contain dirt and
sediments, or nmsh and cake, and will create
maintenance problems.
• Keep the salt hole cover in place on tile softener
unless servidng the unit or refilling with salt,
A WARNING:Do notuse with water that is
tnicrobiologically unsale or ofunknox_ll quality
without adequate disinlection belore or after the
system.
PROPERINSTALLATION
This water softening system must be properly installed and located in accordance with the Installation
Instructions before it is used.
• Install or store where it will not be exposed to
temperatures below fleezing or exposed to a W type
of weather. Water fieezing in the s):stem will break it.
Do not attempt to treat w:lter {)ver 1O0°F,
• Donotinst'all in (firect sunlight. Excessive sun
heat Illay cause distortion or other damage to
non-tnetallic parts.
• Properly ground to conform with all governing
(odes and ordinan( es.
• Use only lead-flee solder and fluxfi)r all sweat-solder
(onne(tions, as required by state and federal (odes.
• The water softening system requires a minimum water
flow of three gallons pet minute at the inlet. Maximum
allowable inlet water pressure is 125 psi. Ifda)aime
pressure is over 80 psi, nighttime pressure may exceed
the maximum. Use a pressure redudng xvllve to re&me
the fl_)wif ne_ssa U,
• Softener resins may degrade in the presence of
chlorine above 1 ppm. Ifyou have chlorine in excess
of this amount, you may experience less life of the
resin. In these conditions, you may wish to consider
purchasing a (;E point-oi:ent U household fihration
system with a dflorine reducing fiher.
A WARNING'.Discard all unused parts and packalging
material after installation. Small parts remaining
after the installation couM be a choke hazard.
READANDFOLLOWTHISSAFETYINFORMATIONCAREFULLY.
SAVETHESEINSTRUCTIONS
Loading ...
Loading ...
Loading ...