Loading ...
Loading ...
Loading ...
Step 6
a. Cable ties (1) and (2) will be used to attach the 12 VDC pump control switch housing and power cord to the discharge pipe.
Installing both cable ties to 12 VDC pump control switch is critical for proper operation of 12 VDC pump. (See Figure 3).
b. Thread cable tie (1) through the eyelets on the 12 VDC pump control switch housing.
c. Position the 12 VDC pump control switch on the discharge pipe such that cable tie (1) is 4" to 6" above the “ON” water level of
the 115 VAC primary pump.
d. Tighten cable tie (1) to secure the 12 VDC pump control switch to the discharge pipe.
e. Install Cable Tie (2) around both the power cord of the 12 VDC pump control switch and the discharge pipe such that the power
cord is securely routed away from any control oats.
f. Use electrical tape to further secure the power cord of the 12 VDC pump control switch to the discharge pipe.
s
!
NOTICE: RS-12 switch cord contains a breather tube. Be sure switch cord is not pinched so that breather tube is obstructed.
Non-restrictive air ow in breather tube is required for proper RS-12 operation.
s
!
NOTICE: For proper pump operation the exit point of all drain piping from the home must be lower, or sloping away, from the
discharge plumbing’s highest point. Improper water drainage can allow freezing within the line leading to system or component
damage or failure.
s WARNING
!
CAUTION
Ensure all hose clamp connections and threaded connections are tight, and that all plumbing slip t
connections are properly glued prior to starting the sump pump system. Failure to do so can result in damage to pump system
and/or cause property damage due to ooding.
s WARNING
!
CAUTION
Do not install or store the pump where it will be exposed to the weather or to temperatures below freezing
or damage to the pump will occur.
13
Loading ...
Loading ...
Loading ...