Loading ...
Loading ...
Loading ...
Initial settings
If an error message is displayed
If all error message is displayed on the TV screen, see "Error
messages" below' to determine the cause and resolve the problem.
Follow' the instructions below' to begin measurement again.
[ERROR E-l]
Press the ENTER key to run the AUTO SETUP procedure again.
Or press the • key to continue the measurement.
[ERROR E-7]
Press the (}) key to turu this uuit to the standby mode, then run
AUTO SETUP procedure again after turning this unit on.
[ERROR E-9]
1 Be sure that a wireless connection betweeu the subwoofer and
center unit has been established (_: p. 20).
2 Press the RETURN key.
The "IntelliBeam" menu is displayed.
3 Select "BEAM+SOUND OPTIM[ZE", "BEAM OPTIM[ZE
ONLY", or "SOUND OPTIM[ZE ONLY" and press the •
key. I)
4 Follow' steps 4, 5, and 6 to measure again (_:p. 25).
[ERROR E-2] through [ERROR E-6]
1 Press the RETURN key.
The "IutelliBeam" menu is displayed.
2 Select "BEAM+SOUND OPTIMIZE", "BEAM OPTIMIZE
ONLY", or "SOUND OPTIMIZE ONLY" and press the •
key. I)
3 Follow' steps 4, 5, and 6 to measure again (_:p. 25).
Error messages
Cause Remedy
There is too much noise in _our Make sure that 2tour listening
listening room. room is as quiet as possible. You
may want to choose certain hours
during the day when there is not
much noise coming from outside.
Cause Remedy
The lntelliBeam microphone is Connect the lntelliBeam
disconnected, microphone to the
1NTELL1BEAM MlCjack on the
rear of this unit and begin
measurement again.
Cause Remedy
Some other operations were Begin measurement again. Do
performed on this unit. not perform any other operations
with this unit during
measurement.
Cause
The hnelliBeam microphone is
not placed in h'ont ol this unit.
Remedy
Position lhe I ntelliBeam
microl?hone in fl'ont ol 1his unit
and begin measurement again.
Cause Remedy
The lntelliBeam microphone is Position the hltelliBeam
not placed in the right distance microphone at a distance of more
from this unit. than 1.8 m (6.0 1:) from this unit
and begin measurement again.
Cause Remedy
The lntelliBeam microphone Position the lntelliBeam
cannot collect the sound microphone properly, check the
produced by this unit. connection, and then begin
measurement again.
Cause Remedy
An internal s}stem error Press the @ key to mrn this unit
occurred, to the standby mode, then run
AUTO SETUP procedure again
after turlfing this unit on.
Cause Remedy
The s[]hx_roo]_r is not connected Be sure that at vvrireless
wirelessly, colmection between the
subwooli_r and center unit has
been established 0_ p. 20) and
measure again.
(3
f
)
ii _i_i;iiiiiiii
_ :7
Z
27 En
Loading ...
Loading ...
Loading ...