Loading ...
Loading ...
Loading ...
8 Cyclone Undermount Installation - English
Preparation for Installation
1. Unpack range hood and check contents. Note: Be cautious
of sharp edges within the unit. Remove hood cover insert
screws and li o cover to expose the inside (Figure 1). For
NA330R/PTB56, to open the cover (bae lter) complete the
following steps (Figure 1a):
i. Pull the bae lter forwards toward the front of the hood
using the handle while pushing the back side upwards
inside the hood.
ii. With the lter tilted upwards, push the lter backward
and then pull down the front to remove the bae lter.
2. Remove either the top or rear electrical knockout depending
on how you plan to run power leads to the hood through
cabinet or wall (Figure 2).
i. Insert a screwdriver into the knockout slot and bend the
knockout back and forth (Figure 3a & 3b). Pliers may be
used to remove the loosened knockout.
3. For rectangular rear venting conguration (Figure 4):
i. Cover the rectangular top cutout with the rectangular
cover plate and fasten with tapping screws. For optimal
use, remove apper for top venting conguration.
ii. Place the rectangular damper onto the rear cutout and
fasten with tapping screws.
Important: Seal both the top cover plate and damper with
aluminum foil tape (preferred) or duct tape.
4. For rectangular top venting conguration (Figure 5):
i. Cover the rear cutout with the rectangular cover plate
and fasten with tapping screws.
ii. Place the rectangular damper onto the top rectangular
cutout and fasten with tapping screws.
Important: Seal both the rear cover plate and damper with
aluminum foil tape (preferred) or duct tape.
5. For round top venting conguration: no rear cover or damper
required.
UNDERMOUNT HOOD INSTALLATION
• Turn o power circuit at the service panel before wiring
this unit.
• All electrical work must be done by a qualied electrician
in accordance with all applicable codes and standards.
is range hood must be properly grounded.
WARNING
• At least two installers are required due to the weight and
size of the hood.
CAUTION
Electrical Knockout
Cover Plate
Tapping Screws
Damper
Cover Plate
Tapping Screws
Damper
Figure 2. Figure 3a, 3b.
Figure 4.
Figure 5.
Bae Removal for NA330R/PTB56:
Figure 1.
Figure 1a.
1. Forward 2. Upwards
3. Upwards
4. Downwards
Loading ...
Loading ...
Loading ...