Loading ...
Loading ...
Loading ...
10 Cyclone Undermount Installation - English
1. Determine mounting height of the hood. Cyclone recommends
that the hood be mounted at a minimum height of:
◆ For gas stoves 30” - 36”
◆ For electric, induction, etc. stoves 28” - 36”
2. Conrm the location of the mounting cleat and check to make
sure it is centered and level. Secure the cleat in place with the
3” wood screws provided. (Figure 1)
Note: make sure the wood cleat is secured and fastened
to all available wall studs (a minimum of 2 studs is ideal)
where there is only one stud available, use drywall anchors
or suitable substitute.
Do not rely on drywall alone to support the hood.
3. Rest the hood on the wood cleat with one person holding
the hood. Score the drywall through at least 2 of the 3 holes
located on the rear panel of the hood for placement of screws
and/or drywall and anchors. Remove the hood and drill pilot
holes into the marks transferred on the wall and add anchors
if there is no stud(s) available.
PTB8 SERIES INSTALLATION
• Turn o power circuit at the service panel before wiring
this unit.
• All electrical work must be done by a qualied electrician
in accordance with all applicable codes and standards.
is range hood must be properly grounded.
WARNING
• At least two installers are required due to the weight and
size of the hood.
CAUTION
Preparation for Installation
1. Unpack range hood and check contents. Please inspect the
product for damage and/or defects prior to installation.
Note: Be cautious of sharp edges within the unit.
2. Conrm that all hardware and accessories are present in
addition to the range hood;
1 - Package containing
◆ 5 x - ⅝” wood s crews for secur ing the top of t he hood
to upper cabinet (if applicable)
◆ 4 x - 3” wood screws for securing the cleat
◆ 4 x - 1 ⅛” wood screws for securing the hood to the cleat
◆ 6 x - ⅝” screws for securing the damper
◆ 1 x - rubber damper seal/gasket
◆ 2 x - wall anchor
◆ 2 x - 1 ¼” screws for anchors
2 - Baffle filters (for 30” model, 3 filters for 36” model)
1 - Grease cup
1 - Wood mounting cleat (strip) - 28.5” x 2” x ¾”
1 - Damper
Preparation for Vent and Exhaust Duct Connection
1. e round vent of a Cyclone Range Hood is 6” (8” for PTB88)
diameter. If the round exhaust duct is not 6” (8” for PTB88)
diameter, a connecting duct is necessary to accommodate the
dierent size. If the exhaust duct is less than 6” (8” for PTB88)
diameter, the eciency of your Cyclone Range Hood will be
reduced and the warranty may be voided.
Wall Mount Installation Instructions
Wall Studs
Stove
Mounting Cleat
15"
30"-36"
Range Hood
Screws
Figure 1
Wall Anchor
Figure 2
Loading ...
Loading ...
Loading ...