Loading ...
Loading ...
Loading ...
ASSEMBLY
Your Craftsman generator requires some assembly
and is ready for use only after it has been properly
serviced with the recommended oil and fuel.
If you have any problems with the assembly of
your generator, please call the generator helpline
at 1-800-222-3136.
Unpacking the Generator
1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner
from top to bottom.
4. Leave generator on carton to install wheel kit.
Carton Contents
Check all contents. If any parts are missing or damaged,
call the generator helpline at 1-800-222-3136.
The generator
Owner's manual
Engine oil
120/240 Volt, 30 Amp locking plug
Wheel kit
Battery charger
Install Wheel Kit
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 1/2" or 13mm wrenches
• Socket wrench with a 1/2" or 13mm socket
• Pliers
• Safety glasses
Install the Wheel Kit as Follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Slide a wheel over the axle.
NOTE: Be sure to install both wheels with the air
pressure valve on the outboard side.
4. Place a washer on axle and then place an e-ring
in axle groove.
5. Install e-ring with pliers, squeezing from top of
e-ring to bottom of axle.
CAUTION
Always wear eye when
6. Repeat step 4 and 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Attach vibration mounts to support leg with 30mm
capscrews, washers and lock nuts.
9. Remove existing hardware from left unit vibration
mount with 13mm wrench. Use same hardware to
attach support leg.
10. Attach other side of support leg with 20mm cap
screw and lock nut.
11. Return generator to normal operating position
(resting on wheels and support leg).
Whee_ Kit Assembly View
Wheel
Use existing hardware
to attach left side of
support leg to unit
Hex Nut _e
Support Leg
Vibration Mount
Axle
\
Cap Screw
Flat Washer
/
E-Ring
Cap
Hex Nut
Loading ...
Loading ...
Loading ...