Loading ...
Loading ...
Loading ...
2423
INSTALLATION
5
MOUNT THE MICROWAVE
OVEN (cont.)
8
7
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Insert2self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
packed with the microwave.
C4.
e the Use and CareeS .sretlif esaerg llatsnI
C5.
INSTALLING OR CHANGE
THE CHARCOAL FILTER
Unplug microwave oven or disconnect power.
1
NOTE: The charcoal filter is factory installed in some
models. Refer to the Use and Care to see if yours is
factory installed and for replacement information.
For models without the recirculation filter access
3
Open the microwave door and remove the two
eht fo pot no detacol; swercs gnitnuom tnev
microwave using a #1 Phillips screwdriver.
2
4
Remove the charcoal filter by pushing the
top of the filter inwards,then pull it forward
out from the unit.
Slide the top of the new charcoal filter into the
top of the filter cavity.
door, follow these steps to replace or install a charcoal
filter.
Charcoal
Filter
INSTALLATION
Close the microwave door. Plug in microwave
oven or reconnect power.
Reinstall the vent by sliding the bottom of the
vent into place. Push the vent top into position
and slide right into place. Replace the two vent
mounting screws located on top of the microwave
using a #1 Phillips screwdriver.
Press the bottom of charcoal filter to place it
into the correct position.
5
6
7
Recirculating
Recirculating
Loading ...
Loading ...
Loading ...