Loading ...
Loading ...
Loading ...
Changing pre-set options
Option Adjustment mode
After using your AquaSm_rt _ you may want to fine tune some of the options to suit your
wash needs. There are a number of preset options, which can be altered. (Note: not all options
are available on the non-dispensing model).
The rinse option.
Changing the cold wash to Controlled Cold.
The number of beeps at the end of the cycle.
The Out of Balance recovery routine.
Resetting the washer back to the settings it left the factory with.
To enter Option Adjustment mode
1 Turn machine on at the wall but do not press POWER.
Press START/PAUSE and hold down, then press POWER.
You will hear three quick beeps and the machine will show an
unusual pattern of lights. Pages 28 -30 explain the different
options in more detail.
2 Use the buttons on the panel to make your changes to the pre--set
options.
s Press POWER to return to normal mode.
4 AquaSmart _ will automatically remember your changes.
Controlled Cold
Fig 19 Pre s 5TAR_PAUSEond
hold down, thenpress POlXI_£
The temperature of cold water varies widely, depending on your location and the season, The
lower the water temperature, the less effective the wash becomes, ]:o help with this issue we
have developed Controlled Cold. This adds a small amount of warm water, when necessary, to
raise your cold water wash to 60°F (15.6°C), This will ensure that you receive the most effective
wash in cold water,
1 Enter Option Adjustment mode (refer above),
2 Select COLD wash temperature,
s The wash cycle buttons show the temperature adjustment possible.
4 When the REGULAR cycle light is on, the machine will fill with cold water only,
s Press the SHEETS cycle button and your Aqu_Sm_rt _ will control the temperature to
approximately 60°F (15,6°C),
Note: If you always use cold or controlled cold water, we recommend that a warm or hot wash is
used regularly, eg. every 5th wash should be at least a warm one,
Hot
Temperature Wum
Fig20 Select Cold W{_sh temperature
Loading ...
Loading ...
Loading ...