Loading ...
Loading ...
Loading ...
Installation Instructions
m CONNECTING THE REFRIGERATOR TO
THE HOUSE WATER LINE (cont.)
[] If you are using copper tubing, place a
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supplg.
If you are using the GE SmartConnect TM
tubing, the nuts are alreadg assembled to
the tubing.
['_ If you are using copper tubing, insert
the end of the tubing into the refrigerator
connection, at the back of the refrigerator, as
far as possible. While holding the tubing,
tighten the fitting.
If you are using GE SmartConnect'" tubing,
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression nut
until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
mag cause leaks.
r_ Fasten the tubing into the clamp provided to
hold it in position. You mag need to prg open
the clamp.
One of the illustrations below will look like the
connection on your refrigerator.
Icemaker-Ready models
Tubing /
Clamp_
1/4" Compression
Nut _
Ferrule f'_
(sleeve)_
Refrigerator
Connection/
1/4" Copper
SmartConnectT_
Tubing
Icemaker-lnstalled Models
Ferrule 1/4"
Refrigerator (sleeve) Compression
Connection-- Nut
SmartConnect_
TubingClamp
I/4"Tubing
21
r_l TURN ON THE WATER SUPPLY
(icemaker and dispenser models)
Turn the water on atthe shut-off valve (housewater
supply)and check for any leaks.
[] PLUG IN THE REFRIGERATOR
On models with an icemaker,before plugging in the
refrigerator, make sure the icemaker power switch isset
to the 0 loft} position.
Seethe grounding information attached to the power
cord.
[] PUTTHE REFRIGERATORIN PLACE
Hove the refrigerator to its final location. Hake sure the
back side of the refrigerator engages the anti-tip
bracket properlg. The anti-tip floor bracket should line
up with the cutout in the back bottom of the
refrigerator, and fit through the cutout when the
refrigerator is pushed into position. (Referto page 18,
Step 2A for more information.)
rsl LEVEL THE REFRIGERATOR
Turn the front roller adjusting
screws clockwise to raise the
refrigerator, counterclockwise
to lower it. Use a 3/8" hex
wrench with extension,or an
adjustable wrench.
Rolleradjustingscrews
To adjust the rollers on 21' CounterDepthmodels:
Thesemodels also have rear adjustable rollers
so gou can align the refrigerator with gour kitchen
cabinets. Use a B/8" hex wrench with extension to turn
the screws for the rear rollers-clockwise to raise the
refrigerator, counterclockwise to lower it.
Loading ...
Loading ...
Loading ...