Loading ...
Loading ...
Loading ...
EN
27
11 Appliance does not spin
Anti-imbalance safety device tripped because laundry not evenly
distributed in drum. If laundry is still wet at end of cycle, rearrange
it in the drum by hand and repeat spin programme only.
12 Emptying water from
drum
In the event of a power blackout or appliance failure, the water can
be removed from the drum using the emergency procedure.
13 Laundry not properly
spun
Large items screwed up and not evenly distributed within drum. Al-
ways wash a mix of large and small items.
14 Traces of detergent on
laundry
Many phosphate-free detergents contain substances with low water
solubility.
Select Rinse programme or brush the laundry.
15 Laundry not dried Check that:
- water tap is turned on
- load of laundry is not excessive
- drying time is long enough
- appropriate drying time selected.
If the appliance still does not dry the laundry, call the Service Centre
to have the fan and drying ducts cleaned to remove any fluff depos-
its.
16 Washing results unsatis-
factory
- Probably too little detergent or unsuitable detergent used
- Difficult stains not dealt with before washing
- Correct temperature not set
- Basket overloaded.
ERROR DISPLAY
In case of a malfunction, the appliance will identify the problem by showing an error code on
the display.
Error code Key to problem
Door not properly closed. Try reclosing.
Aqua stop device tripped. Cut off power supply, turn off water tap and
contact nearest service centre.
Water not taken in for washing. See point 2 in troubleshooting table.
Water not pumped out. See point 4 in troubleshooting table.
No error! The unbalanced load detection system has detected an im-
balance caused by the laundry items. Cannot start "Flusen Spulen (lint
removal)" program. Remove laundry.
For all the other error codes displayed, cut off the electricity supply, turn off the water tap and
contact your nearest Service Centre.
Loading ...
Loading ...
Loading ...