Loading ...
Loading ...
Loading ...
EN
24
Free-Standing Model – Insert a small screw-
driver through the slits in the front of the
plinth, then apply upward leverage with the
screwdriver to release the top of the plinth
from the cabinet.
Tilt the plinth forward slightly and pull it up-
ward to remove it completely.
3. Extract the drain hose ”A”.
Warning: if the hose is hot, the water is hot or
boiling hot. Place a shallow container on the floor
and remove the plug “B” to drain off the water.
Depending on the amount of water in the appli-
ance, the container may have to be emptied sev-
eral times.
When no more water is coming out, close the
hose again by pushing the plug “B” firmly back
into place.
4. Unscrew the cover of the pump “D” by
turning it to the left.
Clean the pump and remove any foreign bodies.
Also check the inside “E”, making sure that the
impeller turns freely; any foreign bodies stuck in
it must be removed.
5. Screw the cover back on the pump.
Secure the drain house by snapping the plug back into place "C".
Depending on the model, replace the plinth as follows:
Built-in/completely concealed model – Fit the bottom of the plinth first. Push it towards the
cabinet and put the plugs back into place.
Free-standing model – Fit the bottom of the plinth first and then push it towards the cabinet
until it snaps into place.
6.5 CLEANING THE DETERGENT DRAWER
The detergent drawer should be kept clean, removing all solid
deposits.
To simplify this operation, completely remove the detergent
drawer (pull the drawer fully out, press in the zone marked PUSH
and then remove completely).
Remove the siphon "A" and clean all parts with hot water.
Fully re-insert the siphon and remove any detergent deposits be-
fore putting the drawer back in position.
Loading ...
Loading ...
Loading ...