Loading ...
Loading ...
Loading ...
7
ENGLISH
FRANÇAIS ESPAÑOL
• This appliance must be properly grounded to minimize risk of electric shock.
• Do not cut or remove the grounding prong from the power plug.
• Attaching the earth wire to the power outlet cover screw does not ground the
appliance unless the cover screw is metal, uninsulated, and the power outlet is
grounded through house wiring.
• If you have any doubt whether the air conditioner is properly grounded, have the
power outlet and circuit checked by a qualified electrician.
• The refrigerant and insulation blowing gas used in the appliance require special
disposal procedures. Consult a service agent or a similarly qualified person before
disposing of them.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person in order to avoid a hazard.
• The appliance shall be stored in a well-ventilated area where the room size
corresponds to the room area as specified for operation.
• The appliance shall be stored in a room without continuously operating open
flames (for example an operating gas appliance) and ignition sources (for
example an operating electric heater).
• The appliance shall be stored so as to prevent mechanical damage from
occurring.
• Unintended use of the appliance or damage to the housing may result in the
escape of dangerous UV-C radiation. UV-C radiation may, even in little doses,
cause harm to the eyes and skin.
• This appliance contains a UV-C lamp.
• When the appliances are damaged or need to replaced, disconnect the power
supply and contact the service center.
• Do not operate UV-C lamp outside of the appliance.
• Do not clean and touch air deflector during operation.
• Before opening doors and access panels bearing the ultraviolet radiation hazard
symbol for the conducting user maintenance, it is recommended to disconnect the
power.
• Read the maintenance instructions before opening the appliance.
• Appliances that are obviously damaged must not be operated.
• The appliance must be disconnected from the supply before replacing the UV-C
lamp.
Loading ...
Loading ...
Loading ...