Loading ...
Loading ...
Loading ...
EN
30
Installation
www.bora.com
Slide the 4 installation clamps [2] until they reach
the stop position in the retaining brackets [1] on the
bottom of the cooktop
Slide the 4 retaining brackets into the fixtures provided
on the bottom of the cooktop.
6.6.3 Inserting the cooktop
54321
Fig. 6.20 Inserting the cooktop
[1] Cooktop
[2] Inlet opening
[3] Air inlet nozzle
[4] Stainless steel grease filter
[5] Worktop cut-out
Before inserting the cooktop, remove the air inlet
nozzle [3] and the stainless steel grease filter [4].
Use the inlet opening [2] as a handle during insertion.
Keep the cooktop [1] straight as you lift it into the
worktop cut-out [5]
Insert the cooktop [1] into the centre of the worktop
cut-out [5].
Precisely align the cooktop.
Information regarding flush installation:
Make sure that the sealing tape of the cooktop is well
sealed all the way round.
Information regarding surface mounting:
Make sure that the sealing tape for the cooktop is flat
against the worktop.
6.6.2 Preparing the cooktop
Attaching the sealing tape
2
1
Fig. 6.17 Sealing tape for surface mounting
1
2
Fig. 6.18 Sealing tape, ush installation
[1] Black, heat-resistant silicone sealant
[2] Sealing tape
With surface mounting, attach the enclosed sealing
tape [2] to the underside of the cooktop before
installing it. Do not leave any gaps.
With flush installation, attach the enclosed sealing tape
[2] to the horizontal cutting edge in the worktop cut-
out, even if you are sealing the cooktop with a silicone
sealing compound [1] or similar.
Fitting the installation clamps
1
2
Fig. 6.19 Inserting the cooktop
[1] Retaining brackets
[2] Installation clamps
INFO 2 installation claps must be fitted to each side of
the cooktop.
Loading ...
Loading ...
Loading ...