Loading ...
Loading ...
Loading ...
ThrottleControlLever
The throttle control lever is
located on the left side of the
tractor's dash panel. This lever
controls the speed of the engine.
When set in a given position, the
throttle will maintain a uniform
engine speed.
IMPORTANT:When operating the
tractor with the cutting deck
engaged, be certain that the
throttle lever is always in the
FAST (rabbit) position.
ChokeControl
The choke control can be found
on the left side of the dash panel
and is activated by pulling the
knob outward. Activating the
choke control closes the choke
plate on the carburetor and aids
in starting the engine. Refer to
StartingThe Engineon page 18 of
this manual for detailed starting
instructions.
BrakePedal
The brake pedal is located on the
right front side of the tractor
above the drive pedal along the
running board. The brake pedal
can be used for sudden stops or
setting the parking brake.
NOTE: The brake pedal must
be fully pressed to activate the
safety interlock switch when
starting the tractor.
DeckLiftLever
Found on your tractor's right
fender, the deck lift lever is used
to change the height of the
cutting deck. To use, move the
lever to the left, then place inthe
notch best suited for your
application.
L
H
IgnitionSwitchModule
WARNING: Never leave a running machine
unattended. Always disengage the PTO,
move the shift lever into Neutral, set the
parking brake, stop the engine and remove
the key to prevent unintended starting.
To start the engine, insert the key into the ignition
switch and turn clockwise to the START position.
Release the key into the NORMAL MOWING MODE
position once the engine has fired.
To stop the engine, turn the ignition key
counterclockwise to the STOP position. See Figure 9.
Stop
Position
Normal
- Mowing Mode
Start
Position
Figure 9
IMPORTANT:Prior to operating the tractor, refer to Safety
InterlockSystemon page 17 and ReverseCautionModeon
page 17 of this manual for detailed instructions
regarding the Ignition Switch Module and operating the
tractor in REVERSE CAUTION MODE.
DrivePedal
The drive pedal is located on the
right side of the tractor, along the
running board. Press the upper
portion of the drive pedal forward
to cause the tractor to travel
forward. Press the lower portion
of the drive pedal with the ball of
your right foot (NOT your heel) to
cause the tractor to travel in
reverse. Ground speed is also
controlled with the drive pedal.
The further forward or rearward
that the pedal is pivoted, the
faster the tractor will travel. The
pedal will return to its original
position when it's not pressed.
IMPORTANT: Always set the
parking brake when leaving the
tractor unattended.
14
Loading ...
Loading ...
Loading ...