Loading ...
Loading ...
Loading ...
49-6000065 13
Installation Instructions
INSTALLATION INSTRUCTIONS
B. OPTIONAL INSTALLATION 1
Utilizing existing kitchen sink water supply valve (A)
and removable faucet tubing (B).
1. Refer to illustration below to complete assembly
depending on supply valve size (A).
2. Close the cold water supply valve (A) under the
sink.
3. Unscrew the flexible tubing line (B) from
the supply valve (A) that connects to the
COLD water riser.
NOTE: For rigid pipe, see D. Optional Rigid Pipe
Installation on page 11.
Note Adapter (C) orientation:
3/8-inch installation—Rounded end of adapter (C)
connects to supply valve (A).
1/2-inch installation—Rounded end of adapter (C)
connects to coupling (D), then to existing faucet
tubing (B).
Feed Water Supply
Check and comply with local plumbing codes as you plan, then install a cold feed water supply fitting.
For 3/8” Plumbing
For 1/2” Plumbing
(B) Faucet
tubing line (not
included)
(D)
Coupling
(C)
Adapter
(F) Inlet valve
(A) Cold water
supply valve
(not included)
(B) Faucet
tubing line
(not included)
(A) Cold water
supply valve
(not included)
(D)
Coupling
(C) Adapter
(G) Gasket
(G)
Gasket
(H)
Ferrule
(F) Inlet valve
(I) Nut
(G) Gasket
A. PREFERRED INSTALLATION
Utilizing existing kitchen sink water supply valve and
removable faucet tubing.
A typical connection using the included water supply
fitting is shown in the illustration below.
1. Close the water shut-off valve that is immediately
in front of the supply tube and open the faucets to
drain water from the sink cold water pipe.
2.
Remove the nut that connects the cold water faucet
to the supply tube. Some water may spill out.
NOTES:
• Be sure to turn off the water supply and open a
faucet to drain the pipe.
• Make sure the gasket is installed in the water
supply fitting.
3. Hand-tighten the water supply fitting onto the cold
water faucet. Be sure the gasket, as shown, is
in place before final assembly. Finish tightening
with an adjustable wrench. Be careful not to
overtighten or cross-thread, since damage to
the threads can occur. Make sure the 1/4” quick
connection is not against a wall that causes the
supply tubing connection to bend. A quarter
turn to tighten or loosen the adapter may be
necessary to avoid this.
4. Reconnect faucet tubing line to the fitting.
5. Install tubing. (See Installing the Tubing section.)
Cold
Water
Faucet
Stud
Cold
Water Pipe
Water Supply Fitting
1/4” Tubing to
Water Filter Inlet
Cold Water Shut-Off
Gasket
Fig. 1
Loading ...
Loading ...
Loading ...