Loading ...
Loading ...
Loading ...
SAFETY & PRECAUTIONS
CONTINUEDCONTINUED
8
USING THE AIR CONDITIONER
AIR CONDITIONER CONTROLS
CONTROL PANEL
• This air conditioner has a control panel lights on o
feature where its lights will turn o when there is no
activity with the controls for over one minute. To wake
up the controls, press any pad on the controls and the
lights will come on to show the previous settings.
• To turn this feature o, press and hold the SLEEP
pad, on the unit, for 5 seconds. The unit will beep to
signal the successful toggle of the feature on and o.
HEAT OR COOL MODE
Use the Heat or Cool mode at Low, Med, High or Speed
for heating or cooling. Use the Temperature Increase
+ / Decrease – pads to set the desired temperature
between 64˚F and 86˚F in 1˚F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on
and o to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
Cooling Descriptions
• For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
• For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
• For Quieter and Nighttime Cooling—Select
the Cool mode and Low fan with a middle set
temperature.
NOTE: If the air conditioner is o and is then
turned on while set to a Cool setting or if turned
from a fan setting to a Cool setting, it may take
approximately 3 minutes for the compressor to
start and cooling to begin.
FAN ONLY MODE
Use the Fan Only Mode at Low, Med or High fan
speed to provide air circulation and ltering without
cooling. Since fan-only settings do not provide
cooling, a Set temperature cannot be entered. The
room temperature will appear in the display.
AUTO FAN MODE
Set to Auto for the fan speed to automatically set
to the speed needed to provide optimum comfort
settings with the set temperature. If the room needs
more cooling, the fan speed will automatically
increase. If the room needs less cooling, the fan
speed will automatically decrease.
ECO MODE
Controls the fan.
• ON—The fan will cycle on and o with the
compressor. This may result in wider variations
of room temperature and humidity. NOTE: the
fan may continue to run for a short time or
may pulse intermittently after the compressor
cycles o to sample the room air.
• OFF—The fan runs all the time, while the
compressor cycles on and o.
REMOTE CONTROLS
• To ensure proper operation, aim the remote
control at the signal receiver on the air conditioner.
• The remote control signal has a range of
up to 20 feet.
• Make sure nothing is between the air conditioner
and the remote control that could block the signal.
• Make sure batteries are fresh and installed
correctly as indicated on the remote control.
AIR DIRECTION
Use the levels to adjust the air direction left or right. Tilt the louver to adjust up or down.
NOTE: Do Not Operate in Freezing Outdoor Conditions:
This cool-only air conditioner was not designed for freezing
outdoor conditions. It must not be used when the outdoor
temperature is below freezing (32°F).
(Continued)
Loading ...
Loading ...
Loading ...