Loading ...
Loading ...
Loading ...
(Continued)
13
Top Rail
Window Sash
About
5°
Bottom Rail
SILL
INSTALLATION INSTRUCTIONS
A.
A.
C.
D.
E.
C.
C.
4
PREPARE THE CASE
A. Install top mounting rail (if not already installed)
with four type A screws.
B. Slide left-hand curtain assembly into left end
of top and bottom mounting rail. Repeat for
right hand curtain assembly.
C. Fasten curtain retainer strips to the sides
of the outer case with four type A screws
on each side. Use 4 type B screws to
secure the side panels in place.
” Self Tapping Screws
(install from interior)
" Self Tapping Screws
(install from exterior)
Top Channel
Side Curtains
5
PREPARE WINDOW FOR INSTALLATION
A. Measure the width of the window opening.
B. Mark the center line on the inside windowsill.
C. Apply the weather seals provided to
the bottom, top and sides of the window
to the seal around the perimeter of the
air conditioner.
6
INSTALL OUTER CASE IN WINDOW
A. Place outer case in window. Lower sash
until it rests behind front ange of top
mounting rail. Bottom mounting rail must
rest behind window sill.
B. Expand the curtain panels to ll the window.
Secure with type C wood screws in top and
bottom corners. If needed, use drill and ”
drill bit to drill pilot holes for the screws.
C. Use three type C screws to secure the case to
the window sill. Drill pilot holes, if necessary.
D. Thread nut onto bolt, then thread the bolt into
the triangle bracket as shown in Figure D.
E. Attach triangle bracket onto bottom of case
using three type B screws for each bracket.
Make sure that the bracket is close enough to
the outside wall that the bolt can touch. Adjust
bolt so that it is snug against the outside wall.
NOTE: Attach accordion panels to the air conditioner
before placing the air conditioner in the window.
A.
Center Line
B.
Cut and apply weather
strip to front and bottom
edge of window frame.
1”
Wood
Screws
1” Wood
Screws (2)
Cut and apply
weather
strip to back
edge of the
windowsill.
Cut and apply a
weather strip to back
edge of the window sill.
Loading ...
Loading ...
Loading ...