Denali Aire 2DANC24K User Manual

Loading ...

USING THE AIR CONDITIONER

Delay Pad

• Delay ON—When the air conditioner is o, it can be set to automatically come on in 1 to 24 hours

at its previous mode and fan settings.

• Delay OFF—When the air conditioner is on, it can be set to automatically turn o in 1 to 24 hours.

How to set:

Press the Delay 1–24hr pad on the unit or the remote control. Each touch of the Increase + /

Decrease – pads on the unit or the remote control will set the timer in 1-hour intervals.

To review the remaining time on the Delay 1-24hr timer, press the Delay 1-24hr pad on the unit

or the remote control. Use the Increase + / Decrease – pads on the unit or on the remote control

to set a new time if desired.

To cancel the timer, press Decrease – pad on the unit or the remote control until the set time is zero.

After 3 seconds the light on the Delay 1-24hr pad goes o.

Sleep (set from air conditioner panel only)

• SLEEP mode will gradually change settings over an 8-hour period to allow energy eciency

during sleeping hours. The SLEEP mode is available only in COOL and FAN ONLY settings.

• Press the SLEEP mode and the light will illuminate. The fan indicator will stay at the same setting, but

the air conditioner will automatically change FAN speed to low in either COOL or FAN ONLY mode.

• In FAN ONLY mode, the fan will stay in the LOW speed setting for 8 hours. After 8 hours, the air

conditioner will resume the settings that was in place before the SLEEP mode was pressed.

• In COOL mode, the fan will stay in the LOW speed setting for 8 hours from the time the SLEEP

mode pad was pressed. The air conditioner will also raise the set point 2°F in 30 minutes and 2°F

more in another 30 minutes where it will remain for the next 7 hours. After 8 hours, the air conditioner

will resume the settings that were in place before the SLEEP mode pad was pressed.

• While the unit is in SLEEP mode, pressing any pad will return it to the settings that were in

place before the SLEEP mode pad was pressed.

Filter Reset Pad

• This feature automatically noties you that the air lter must be cleaned. The indicator light will

come on after 250 hours of operation. Clean the air lter (refer to page 8), place it back in the

front panel, and press the Filter Reset pad. The light will go o.

(Continued)

Loading ...

Denali Aire 2DANC24K 23,500 BTU 230-Volt ROOM AIR CONDITIONER