Loading ...
Loading ...
Loading ...
page 10
11. Automated Learning Process./Activating Code.
CAUTION: The wall and/or handheld remote control can be
programmed to multiple receivers or fans. If this is not desired, turn
wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider
switch on wall control to the ON position. Within 60 seconds of
turning on the wall control, press and hold the fan OFF button on
the wall control for 5 seconds (or until light blinks twice or fan
blades begin to turn).
Turn power off again for at least 5 seconds and then turn power
back on. Within 60 seconds of restoring the power, press and hold
the OFF button on the front of the handheld remote control for
5 seconds (or until light blinks twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is
complete--see Section 13 on the following page.
10. Handheld Remote Control Assembly. (cont.)
Attach black faceplate to front of wall control; press
down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and press
together firmly. Place wall control into BOTTOM part
of remote control cover, aligning posts in top of
remote control cover with post holes in the bottom.
[Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and
bottom of remote control cover together until you
hear a click at each end, indicating that the remote
control cover has closed completely.
IMPORTANT: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if handheld remote control will not be used
for long periods.
CAUTION: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When
disposing of household alkaline batteries, it is best
to check with your local and state recycling or
household hazardous waste coordinators
concerning the specifics of the program in your area.
You may also locate a recycling center by calling
1-800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
diagram 3
11
-
DIM ON
wall
control
face-
plate
remote control
cover, BOTTOM
post
hole
post
hole
remote control
cover, TOP
Loading ...
Loading ...
Loading ...