Loading ...
Loading ...
Loading ...
16
Power Supply Cord Kit
The power supply cord will be connected to the terminal connecon block located behind
the back panel access cover by manufacture. This appliance should be connected by
means of permanent "hard wiring" or by means of a power supply cord kit.
Risk of fire or electrical shock exists if an incorrect size range cord kit is
used, the Installation Instructions are not followed, or the strain relief bracket is
discarded.
Terminal on end of wires must be either closed loop or open spade lug with upturned
ends. Cord must have strain-relief clamp.
CAUTION: Do not loosen the nuts which secure the factory-installed range wiring to
terminal block while connecng range. Electrical failure or loss of electrical connecon
may occur.
Access to Terminal Block
Remove the screws at the lower end of the rear access cover and take it down to expose
range terminal connecon block.
a) only a 4-conductor power-supply cord kit rated __240__
volts, __30A__ amperes
minimum and marked for use with ranges shall be used; and
b) used closed-loop terminal that the cord kit is to employ, as appropriate for the
appliance supply terminals.
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE
WWW.KUCHT.COM
Loading ...
Loading ...
Loading ...