Loading ...
Loading ...
Loading ...
MAINTENANCE INSTRUCTIONS
Usingdistilledwater, fill cells as needed to 1/8" to 3/8"
above cell plates.
Replace cell covers.
Charge battery if required.
Install positive(+) cable first.
Install negative(-) cable last.
Install seat assembly over battery and secure in position
with adjusting knobs. Leave knobs loose.
Lower operator's seat and adjust to desired position.
Raise seat and tighten adjusting knobs.
BATTERY CHARGING
The engine is equipped with a flywheel alternator to
charge the battery. If the tractor is not run regularly,
connect the battery to a charger monthlyto maintainthe
specific gravity at 1.250 or higher. If this reading falls
below 1.175, the batteryliquidmay freeze whentempera-
turesdropto around zero degrees F. To charge, connect
perinstructionsfumishedwithcharger,If time allows, slow
charge at 1 amp for ten hours, or as an alternate, fast
charge at 3 amps forfour hours. Observe all precautions
while charging.
.LEY
TRACTION DR! VE-BEL T
Check the tractiondrivebeltfordamage andwear after25
operatinghours. The traction drive belt is locatedon the
undersideofthe tractorandspansfromthe enginepulley's
top groove to the transmissionpulley. See Figure 35.
TRACTION --
DRIVE BELT
FIGURE 35
21
Loading ...
Loading ...
Loading ...